Erickson ATV E-Track Tie-Down Kit Review Video

Erickson has the spacing for the mounting holes of the #EM09160 before and after the chock at approximately 4-3/8" center to center. Since they unfortunately do not offer a custom backing plate the #e96RR you purchased is going to be the closest…

The safest way to secure a 4-wheeled vehicle like a golf cart in a truck bed is to use wheel nets that secure to the truck bed in some manner. The Erickson E-Track Tie-Down Kit #EM09160 is one option that is similar to the Pack 'Em kit you…

Erickson does offer a zinc-plated steel backing plate for use with their E-Track products like their ATV E-Track Tie-Down Kit #EM09160. Use part #e96RR. You can see this item's hole dimensions and spacing in the linked photo. Since your trailer…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The short answer is maybe. In order for the tailgate assist to work correctly, the side rails of the trailer should be 10-15 inches high, and the tailgate at least 44 inches tall when in the upright position. If the dimensions of your trailer fall…

I spoke to my contact at Rackem and the Rack'em Double Barrel Trailer Tailgate Assist #RA-27C that you referenced has to be installed on a side rail between 10-15 inches in height, preferably 12 inches tall.

I contacted Erikson and they told me the straps of the ATV E-Track Tie-Down Kit #EM09160 should not be used diagonally, and that it is illegal to do so. You might contact your local DOT to check this for your specific area. Erikson also verified that…

The width of the Optronics Flexible LED Light Strip #UCL90CB is about 3/8". I have attached a review video where we take this measurement for you to check out. To help remove the 3M adhesive I recommend using some heat like a hair dryer or…

On a Class I or II 1-1/4 inch trailer hitch you will need to use a 1/2 inch hitch lock such as #e98879. This lock has a 2 inch span which is the usable length of the pin. I have included a link to a video review for you. For a Class III or IV 2 inch…

The Erickson ATV E-Track Tie-Down Kit #EM09160 is intended to secure your trailered 4-wheeled vehicle at the rear tires. The chocks are to be mounted in front of and behind the rear wheels as shown in the linked video and photo. If they were…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

It looks like each chock and strap from 2 of #EM09160 will need to be able to hold around 375 pounds to handle the weight of the 2014 Arctic Cat Wildcat X Limited and that is just static load and does not include the forces applied to the chocks and…