Can I Use 1/2" Longer Shackle Straps for My Trailer Suspension

Question

Question:

I bought Shackle 1/2 inch too long. Can I still use them?

asked by: Shaun P

0

Expert Reply:

If the shackle straps are within a 1/2" of what you normally had, say the 2-5/8" # 115052 to 3-1/8" # TRSL313, you should be okay to install them. Just make sure that all of your shackle straps match though. If you are using the longer straps only for a section of your suspension setup then that will cause issues for your trailer.

expert reply by: Jon G

0

Answer 1

The measurement of the Replacement Hitch Ball for B&W Turnoverball Underbed Gooseneck Hitches - 2-5/16" #BWGNXA2000 is 2-1/2 inches by 2-1/2 inches by 4 inches. The ball on top of this shank is 4-1/16 inches tall. The hitch pin hole is…

view full answer...

Answer 2

When replacing shackle straps they should be the same length as the ones that were previously on your tandem axle trailer; replacing them with longer straps will result in additional play in your trailer suspension which could lead to additional wear…

view full answer...

Answer 3

The shackle straps included in the Lippert Tandem Axle Equa-Flex AP Kit - Wet Bolts - 3-1/8" Long Shackles #LC64FR you mentioned are 3-1/8" center to center and 4-3/8" overall length as shown in included diagram. Using the longer…

view full answer...

Answer 4

Is the trailer sitting nose high or low? If the trailer isn't sitting perfectly level that is a typical cause for the shackle straps to flip upside down. Or if they are too short for the application that could cause a problem. I attached a link…

view full answer...

Answer 5

The first thing I would check on your trailer is the capacity of the springs. You need to be sure the spring capacity is rated at 1/2 the axle capacity. That way 2 springs equal the capacity of the trailer axle for proper fit. Check the arch of the…

view full answer...

Answer 6

Trailer manufacturers don't usually keep a record of parts like these that they install at the factory, so I cannot be sure as to the exact length of the shackle strap that would have come originally on your trailer. With this in mind, a 3-1/8…

view full answer...

Answer 7

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 8

What I recommend, if the trailer has round axles, is an over-under conversion kit. For 3 inch round axles use #K71-385-00 and for 2-3/8 inch round axles use #K71-384-00. This of course will only work if the leaf springs are mounted to the bottom of…

view full answer...

Answer 9

I have checked the installation instructions for the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00, and according to Dexter they strongly recommend tack welding the spring seats in place. Please note that this kit is intended for use…

view full answer...

Answer 10

I do have a few possible options for giving your 2004 Toy Hauler some extra clearance for your larger 29-1/4 inch tires. Replacing the Double-Eye Springs and upgrading to a 5 leaf or 6 leaf spring system will provide very minimal rise on your trailer…

view full answer...

Answer 11

Typical spring deflection for trailer leaf springs like the part #e64SR is right at 1-1/2 inches when at capacity. Generally speaking you will want to have 3 inches from the top of your tire to a fender on a trailer (in your case a deck) to…

view full answer...

Answer 12

The recommended amount of tire clearance to allow for suspension travel on virtually any trailer is 3" from the top of the tire to the bottom of the fender or frame and 1" from the inside of the tire to the frame. If you need to raise the…

view full answer...

Can I Use 1/2" Longer Shackle Straps for My Trailer Suspension

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching