How to Know What Side the Lippert 3.0 Replacement Leg Goes On

Question

Question:

Is left and right orientation of trailer legs while standing in front of trailer looking towards rear?

asked by: Paul

1

Helpful Expert Reply:

The orientation of left and right is most easily explained like you are in a drivers seat. So when seated in a drivers seat your left side is left and your right side is right. So the Replacement Short Left Rear Leg # LC342610 would be for the drivers side of your trailer.

expert reply by: Scott S

1

Answer 1

There have been 2 different heights of smaller legs that come with the Lippert Ground Control 3.0 #LC675817 over the years so you'll need to measure and see if you have the 22-1/2" or the 24-1/2" rear legs in order to choose the correct…

view full answer...

Answer 2

I have a ground clearance answer for you. As far as the shortest retracted length, the Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System #LC428493 and the Replacement Short Left Rear Leg - Ground Control…

view full answer...

Answer 3

I was honestly unsure on whether the jacks are interchangeable so I reached out to the manufacturer. For the most part you can use the Replacement 22-1/2" Left Rear Leg for Lippert Ground Control 3.0 Electric Leveling System #LC342610 (428493)…

view full answer...

Answer 4

Lippert actually has 2 inch shorter versions of the rear jacks of the Lippert ground control with the part #LC342610 for the left rear and then #LC428493 for the right hand side. We also have the lift kit part #RR23QX which can give your trailer a…

view full answer...

Answer 5

The Replacement Left Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1 #LC305339 is the replacement leg you want. The Lippert #LC342610 is 2 inches shorter and is for travel trailers with this system versus 5th wheel…

view full answer...

Answer 6

It sounds like you have the Lippert Ground Control Auto Leveling Landing Gear 3.0 part #LC358590 and are looking for replacement rear landing gear legs. For that you would want the part #LC344792 for the rear right leg and the #LC305339 for the rear…

view full answer...

Answer 7

Yes, the left rear leg for the Lippert Ground Control 3.0 Electric 4 Point Leveling System is the same as the left middle leg for the Lippert Ground Control 3.0 Electric 6 Point Leveling System. If your left middle leg measures 17" long then you…

view full answer...

Answer 8

On the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 the following jacks are used. Front Landing Gear #LC305340 Left Middle Jack #LC305339 Right Middle Jack #LC344792 Left Rear Jack #LC342610 Right Rear Jack #LC428493

view full answer...

Answer 9

I assume you have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC358590? If that is the case then there is a manual override on both the top of the motor and bottom of the leg for each jack. Since the jack is retracted…

view full answer...

Answer 10

Can you please tell me what the exact fault you are seeing on the touchpad is? In the owner's manual it displays a list of different fault codes in addition to the corrective procedure. I would need to know what fault code you are seeing in order…

view full answer...

Answer 11

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 has 4 35-amp fuses located on the controller. Attched is a complete wiring diagram for you to check out.

view full answer...

Answer 12

The 676004 number you provided as a replacement fuse for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590 returns to a 30A fuse instead of a 35A fuse. That being said, we do not carry that fuse. You can however take your…

view full answer...