Lippert Ground Control Replacement Leg Review Video

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

For your 4 point Lippert Ground Control leveling system the correct wiring harness you need for the right/rear jack is the part #LC65ED and then for the correct replacement jack you would need the part #LC428493 and you'd be set with…

I reached out to Lippert to confirm that you can change out your 24-1/2" rear jacks that come with the 4-Point Lippert Ground Control 3.0 #LC358590 with the Short Left Rear Leg #LC342610 and Short Right Rear Leg #LC428493. They confirmed…

All of the brake hoses, including the main brake line, are made of rubber on the 20 foot Kodiak Hydraulic Brake Line Kit - Tandem Axle #20TA-BLKIT. The hoses on the #20TA-BLKIT also have brass fittings with stainless steel flares.

The Replacement Left Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1 #LC305339 has the following dimensions: 9 inch diameter foot plate 23-1/2 inches tall without foot plate 8-1/2 inches wide at widest point…

So it sounds like it is the "passenger's" side of the trailer which would be the right side. That would mean rear leg #LC344792 is the correct replacement for you.

Yes, you can use 2 of the Timbren Axle-Less Trailer Suspension Kits #ASR35HDS02 which will give you a total trailer GVWR of 7,000lbs. Do understand you must include the weight of the trailer into this calculation. If you are needing to carry 7,000lbs…

Installation of the #LC305339 will only require plugging the leg wiring harness into the wiring harness attached to your controller. I have attached a wiring diagram for the 4-point and 6-point system below.

The direction labels on the replacement jacks for your Lippert 4-Point Ground Control 3.0 System #LC358590 are determined when facing the rear of the trailer (in the direction of travel). For the right (passenger's side) rear replacement leg you…

Lippert does sell the motor separately but unfortunately not the leg unit. If you are needing the leg unit then you will need to purchase the entire rear jack. Thank you for the picture and your description. Between the Replacement #LC305339 and…

I was honestly unsure on whether the jacks are interchangeable so I reached out to the manufacturer. For the most part you can use the Replacement 22-1/2" Left Rear Leg for Lippert Ground Control 3.0 Electric Leveling System #LC342610 (428493)…

Yes it does, what you will need are 1/2"-20 self-tapping bolts in order to install the bracket you asked about: - Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975