Review of Lippert Components - Trailer Jack,Camper Jack - LC349975 Video

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

I attached a dimension picture I got from Lippert for the Replacement I-Beam Jack Bracket #LC349975 that you referenced.

Yes it does, what you will need are 1/2"-20 self-tapping bolts in order to install the bracket you asked about: - Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 #LC349975

The Replacement Short Left Rear Leg #LC342610 uses 1/2"-20 x 1-1/2" bolts to attach to the Jack Bracket for Lippert Ground Control 3.0 #LC349975. I'm not entirely certain what you are referencing in terms of "whole…

To install the Replacement I-Beam Jack Bracket #LC349975 for Lippert Ground Control 3.0 #LC358590 you'll need to follow the instructions that came with the Lippert Ground Control 3.0. I've attached a cutout from the instructions for…

All of the brake hoses, including the main brake line, are made of rubber on the 20 foot Kodiak Hydraulic Brake Line Kit - Tandem Axle #20TA-BLKIT. The hoses on the #20TA-BLKIT also have brass fittings with stainless steel flares.

I have attached for you below the complete dimensions of the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 part #LC349975 to the degree that Lippert was willing to share. If you require further dimensions, I'd need to know…

The overall height of the mounting plate of the Replacement I-Beam Jack Bracket for Lippert Ground Control #LC349975 is 13 inches.

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 is designed for use with fifth wheels and would work extremely well for your 2006 Keystone Raptor. It has six jacks, with two landing gear jacks that mount to existing…

So it sounds like it is the "passenger's" side of the trailer which would be the right side. That would mean rear leg #LC344792 is the correct replacement for you.

If the jack setup on your 2019 Montana legacy 3120RL is a Lippert Ground Control setup then yes, the LC349975 would be the correct replacement and could be welded on. If you have something different though I can not guarantee this will work.

I'm attaching a diagram we made for the dimensions of the smaller jacks that come with the Lippert Ground Control 3.0 #LC358590. Please note that there is some wiggle room as to where you can mount the rear jacks. If you check out the linked…