Does The Air Lift LoadLifter 7500 XL Have An Internal Jounce

Question

Question:

Does this come with a internal bump stop and if so is there a part number that doesn’t. Also I seen on some other q&a that there are different heights I would like a 6” without bump stop if they make it.

asked by: Jacob H

0

Expert Reply:

Yes, the Replacement Air Spring for Air Lift # AL50236 for the Air Lift LoadLifter 7500 XL # AL57538, does have an internal jounce. If you want 6" air springs, you'll want the Air Lift LoadLifter 5000 Air Helper Springs # AL57385.

# AL57385 fits a 2015-2020 Ford F-150, so if that's what you have then these will work great for you.

expert reply by: Bryce D

0

Answer 1

Air Lift LoadLifter 7500 XL Air Helper Spring kit #AL57538 will fit both the 2WD and 4WD versions of the 2019 Chevrolet Silverado 3500HD with factory 5th wheel/gooseneck prep but you will need to drill to install it. The kit brackets will install to…

view full answer...

Answer 2

For your Demco Hijacker Autoslide 5th Wheel Trailer Hitch w/ Slider - Single Jaw - Underbed - 18,000 lbs #DM8550022 the Underbed Rail and Installation Kit for Demco Hijacker UMS 5th Wheel and Gooseneck Trailer Hitches #DM8551010 will work well.…

view full answer...

Answer 3

The distance between the rails should be center to center 22" (pictured below). This rail spacing is considered industry standard. I've attached the installation video for the custom fit B&W rails #BWRVK2401 to help you with the…

view full answer...

Answer 4

There is a possibility that the Capture Plate for Pullrite SuperGlide Hitches will work with a Demco Hijacker Autoslide 5th Wheel Trailer Hitch but I cannot confirm this nor recommend you use one with the other. If everything locks into place when…

view full answer...

Answer 5

Yes, the Replacement Air Spring for Air Lift LoadLifter 7500 XL System #AL50236 does have an internal jounce bumper. This air spring is a replacement hybrid spring for your Air Lift LoadLifter 7500 XL Air Helper Spring System, and is made in the USA.…

view full answer...

Answer 6

The Furrion cameras, like what comes in the part #FOS43TASF that replaced the part you referenced, are only compatible with their specific monitors. If you are looking for a camera system that allows you to use your smartphone as the monitor then I…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 11

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

view full answer...

Answer 12

The Air Lift WirelessONE Compressor System #AL25980EZ and Air Lift WirelessONE Compressor System #AL25980 are nearly identical with only some very minor differences in CFM and duty cycle ratings. The #AL25980EZ will also come with an easier mounting…

view full answer...