Is There Any Way to Install Tekonsha Trailer Wiring Harness 118667 on 2010 Volkswagen Golf

Question

Question:

Can I make this kit work on my 2010 VW golf? I already have the kit. Thank you

asked by: Jay

1

Helpful Expert Reply:

The # 118667 cannot be used on your 2010 Volkswagen Golf you would need a new harness like the # C59236 which is a confirmed fit. The connectors and wiring configuration of your Golf would not work with the harness you mentioned.

expert reply by: Jameson C

1

Answer 1

We do not recommend using the 12 volt power outlet in the trunk area for connection of a powered circuit protected wiring harness, like the Curt Hardwire Kit, #C59236, which includes the wiring to the battery. The purpose of the power wire is to…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The (discontinued) Tekonsha Powered Tail Light Converter 119190KIT is a universal wiring harness so there aren't any specific instructions when it comes to installing the kit on your 2013 Volkswagen GTI. With that being said, we did get the…

view full answer...

Answer 4

The Curt Spectrum Brake Controller, part #C51170, will work for your 2010 Volkswagen Golf. With limited space, the option of three separate components can prove to be a benefit. It features seven sensitivity levels that allow you to adjust the…

view full answer...

Answer 5

The trailer wiring harness we offer for your 2015 Volkswagen Golf SportWagen is the Curt Harness, part #C59236. This harness is a hardwire installation so I have attached a drawing that shows how it should be installed. This harness will work with…

view full answer...

Answer 6

I have a solution for you but there are no plug and play adapters for your 2014 VW Jetta Sportwagen. For a 4-flat connector you are going to want the Curt Wiring Harness Kit w/ 4-Pole Trailer Connector and Installation Kit item #C59236. This kit…

view full answer...

Answer 7

The Curt wiring harness you referenced, part #C59236, will work fine on your 2014 Volkswagen Jetta TDI SportWagen. The linked article will also be helpful to your installation by providing tips for routing the harness power wire.

view full answer...

Answer 8

We do have a wiring harness fit for your 2010 VW Jetta SportWagen TDI, and the correct fit is a hardwire option, which is the following part - Curt Vehicle Wiring Harness #C59236

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Is There Any Way to Install Tekonsha Trailer Wiring Harness 118667 on 2010 Volkswagen Golf

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching