Can The Valterra EZ Valve Electric Waste Valve Replace the Manual Valve Already On My Camper?

Question

Question:

Will this valve also work where all black and gray water leave the Rv….in the sewer line?

asked by: Todd

0

Expert Reply:

Yes, the Valterra EZ Valve Electric Waste Valve # E40B-8 uses the same size 3" Slip Hub with Flange # T1005 that you have on your sewer line already.

The Valve may benefit from being installed up in your enclosed underbelly with the Valterra ABS Solvent Cement # A05-0303 if you do camp when the weather is colder to help prevent the sewer pipes from freezing. It will also protect the valve from damage caused by road debris while you are driving.

expert reply by: Bud M

0

Answer 1

Yes, the Valterra EZ Valve Electric Waste Valve for RV Black Water Tank #E40B-8 can be oriented sideways so it's able to open up under your trailer. The 3" to 3" hubs mentioned in the description are included with the valve.…

view full answer...

Answer 2

The outer diameter of the Valterra #T1005 is 3-1/2 inches and the inner diameter is 3 inch.

view full answer...

Answer 3

Hey Wyatt, so we have a hose that was designed to be used with the #T01-0091VP with the part #W01-4180 which does have a different thread size. This is intentional so that someone doesn't use a standard garden hose that someone might attempt…

view full answer...

Answer 4

Hey Gene, we don't have that exact one you're looking for but we do have the Vitrifrigo C85i RV Mini Fridge with Built-In Freezer #VT34FR which is 3.2 cubic feet, runs off of 12V power, and does include a built in freezer.

view full answer...

Answer 5

This is a pretty common issue as the 12 volt accessory/charge circuit is not always active on vehicles with OEM 7-ways. The solution is to run 10 gauge wire like part #10-1-1 (sold by the foot) through a breaker like part #9510 between the 1:00 pin…

view full answer...

Answer 6

Hey Lamar, The Demco Autoslide 5th Wheel Hitch w/ Slider #DM69GV has side plates with attachment points that will drop right into your Ram's puck system an without the need of any other kind of adapters or rails. The only thing you might need…

view full answer...

Answer 7

The difference between a hub connection and a spigot connection is that the hub is the female end and has a lip on the inside that stops the spigot (or male) end where it needs to be. I have attached some pictures to assist. With this knowledge it is…

view full answer...

Answer 8

To make your life easier you could just remove the center section of your current waste valve and then install just the center section of the part #E40B-8 so that you can convert to an electric setup without having to deal with a much more involved…

view full answer...

Answer 9

The distance from the top of the mounting plate to the bottom of the housing on the Bulldog Powered-Drive Trailer Jack, #BD500200, is 13 inches.

view full answer...

Answer 10

The Valterra EZ Valve Electric Waste Valve for RV Black Water Tank item #E40B-8 may benefit from being installed up in your enclosed underbelly with the Valterra ABS Solvent Cement item #A05-0303 to help prevent the sewer pipes from freezing if you…

view full answer...

Answer 11

Yes you are correct Valterra EZ Valve Electric Waste Valve for RV Black Water Tank part #E1003VP does come with everything you will need. The confusion came from the spigot or hub ends and which one they needed for their application in that question.…

view full answer...

Answer 12

Yes, the MORryde Suspension Upgrade Kit #MR46ZR can certainly be used with the Lippert Road Armor Equalizers. You will just want to be sure that the stock shackle links on your 2021 Cougar 29RKS are 2-1/4" long when measured center hole to…

view full answer...

Can The Valterra EZ Valve Electric Waste Valve Replace the Manual Valve Already On My Camper?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching