Does Curt 2 to 3 Tail Light Converter # C56196 Run to Right Turn/Stop Circuit of Vehicle
Question:
So, I put this harness on the left rear brake light. My question is do I need to run wire to the right rear brake light if I do im assuming under the truck bed. Im trying to understand this. I rather learn then have somebody else work on my truck.
asked by: Scott C
0
Expert Reply:
You would need to run wire to the right rear brake light to install the part # C56196 that you referenced. Basically the yellow wire runs to the left turn/stop and the green runs to the right turn/stop and the white is grounded.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt 2 to 3 Wire Tail Light Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Wiring
- Article: Trailer Wiring Diagrams
- Shop: Curt 2 to 3 Wire Tail Light Converter
- Shop: Tail Light Isolating Diode System with Wiring Harness
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Video: This Old Trailer: Installing a Trailer Clearance Light
- Search Results: 56196
- Shop: Vehicle to Vehicle Tail Light Converter
- Q&A: Troubleshooting Install of Turn Signal Converter Not Functioning on Trailer with Separate Lights
- Q&A: Is It Normal for Brake Lights Instead of Turn Signals to Flash When Using Hazards With Converter
- Search Results: 2 wire to 3 wire tail light converter
- Shop: Armored Clearance and Side Marker Trailer Light - Incandescent - Steel Housing - Amber Lens
- Shop: Peterson Armored Clearance and Side Marker Trailer Light - Incandescent - Steel Housing - Red Lens
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Video: Curt Tow Bar Wiring C56196 Review
- Q&A: Hazard Light Signals From Curt Vehicle to Vehicle Tail Light Converter C56196
- Q&A: Do Clearance Lights Need Signal Wire and Brake Light Wire Spliced In?
- Q&A: Troubleshooting Curt 2-Wire to 3-Wire Converter Installation on Trailer
- Q&A: How to Convert a Trailer with Combined Taillights to Separate Taillights
- Search Results: curt 56196
- Video: Review of Hopkins Wiring - Trailer Connectors - HM48847
- Search Results: 3 to 2 wire converter
- Shop: Roadmaster Brite-Lite Wiring Converter
- Search Results: 25580
- Shop: Trailer Wiring
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Search Results: safety chains
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: break away switch