Friction Sway Control Ball Mount Bracket Solution for Hitch Ball with 1-1/4 inch Shank

Question

Question:

Im looking for a bracket for my trailer hitch to add a anti sway system. I have a Curtis hitch with 2 and 5/16 ball that has a 1 1/4 shank.

asked by: Mike M

0

Expert Reply:

You could use a weld on tab for the side of your current ball mount with the part # C45822 but since the shank diameter of your ball is 1-1/4 inch there isn't a bracket that can fit under your ball as for that style there's only options that fit the 1 inch diameter shank balls.

expert reply by: Jameson C

0

Answer 1

Yes, the Curt RockerBall 2-5/16" Shock Absorbing Hitch Ball and Ball Mount w/ Sway Control Tab #C45WR will fit and work with the factory 2 inch hitch on your 2021 Audi Q7. The sway control is the Curt Friction Sway Control #17200.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 5

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 6

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

In order to match up the wheel studs for your Reliable 1206 hub, we'll need to know the full dimensions of the wheel stud you're replacing. In addition to the total length of the stud and its diameter and thread pitch, we'll also need to…

view full answer...

Friction Sway Control Ball Mount Bracket Solution for Hitch Ball with 1-1/4 inch Shank

Product Page this Question was Asked From

Continue Researching