Replacement 1/2-20 Wheel Stud For Reliable 1206 Trailer Hub

Question:

I have a trailer hub with H D 1206 and R with an oval circle around it. I need press in wheel studs. !/2 20, 2in long. The trailer was manufactured in 1990. Will the Kodiak K12WB2 work or is there something I dont know.

asked by: Will G

Expert Reply:

In order to match up the wheel studs for your Reliable 1206 hub, we'll need to know the full dimensions of the wheel stud you're replacing. In addition to the total length of the stud and its diameter and thread pitch, we'll also need to know the length of the threaded area of the stud, the length of the splined area and the diameter of the portion that's driven into the hub.

In the case of the Kodiak # K12WB2 wheel stud you mentioned, the diameter of the splined area (portion driven into the hub) is .54 of an inch. The length of the splined area is .42 of an inch. The threaded portion is 1.46 inches long. This is the only stud we offer that's 2 inches long, so if the above measurements match, it would be the correct stud for your hub. I've shown these dimensions on the photo I've edited for you.

expert reply by: Mike L