RV Scissor Jack Solution with Round Upper Mounting Bracket

Question

Question:

Hello, On trailer stabilizer jack number JCS-24, can you purchase replacement foots? Basically what Im after is that jack, but the upper mounting plate needs to be rotated 90 degrees for my trailer application. Currently the jacks mounting plate and feet are opposite of each other. I need one of these jacks to where the foot plate and mounting plate are running in the same direction.

asked by: Donny L

0

Expert Reply:

There isn't a way to rotate the mount in relation to the foot direction of the stabilizer scissor jacks part # JSC-24 and since none of our options are setup like that our best solution would be the # LC285344 which has a round mounting bracket on the top instead.

expert reply by: Jameson C

0

Answer 1

Typically people mount stabilizer jacks like the #JSC-24-IND that you have on the corners of the frame of the RV so that it's as stable as possible. I attached a picture we got from a customer that shows it installed on the corner of the…

view full answer...

Answer 2

Scissor jacks such as #JSC-24-IND used for stabilization of a trailer/RV can be welded or bolted on. However, if you choose to weld them on using a professional welder is recommended. There is no specific way they have to be placed. I have seen…

view full answer...

Answer 3

Without bolting or welding down the scissor jacks #TJSCHD-24-4 they'd still do a decent job stabilizing the camper but considering how much more convenient they are when installed on the trailer I'd recommend you go that route. Would…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

What you are wanting to do is very possible with the GO Power Solar Panel kit part #34273836. You could mount it on your pin box and then run the wiring to your batteries via an SAE connector. We don't have an SAE connector adapter but they are…

view full answer...

Answer 7

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

Answer 8

I have spoken with Lippert about the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817 in they past and they informed me that the most important aspect is that the battery/batteries are sufficiently charged, between 12.4…

view full answer...

Answer 9

You can put a maintenance charge on your trailer battery with the 12 volt accessory circuit of the 7-way. The 1:00 position of your 7-way carries this circuit. You would just need to run a length of 10 gauge wire like part #10-1-1 (sold by the foot),…

view full answer...

Answer 10

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 11

The best modern day size replacement option we have for a 6.00-16 is a 235/80-16 which measures 30-7/8" diameter x 9-3/8" wide. For this, I recommend the Kenda Karrier ST235/80R16 Radial Trailer Tire with 16" Black Mod Wheel part…

view full answer...

Answer 12

A tow package for a vehicle is usually a frame mounted trailer hitch and trailer wiring on a vehicle like your 2002 Dodge Dakota. If you have those two things you could pretty easily assume you have the tow package. Or, you can take the VIN of your…

view full answer...

RV Scissor Jack Solution with Round Upper Mounting Bracket

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching