Replacement Bearings for 2005 Keystone Outback 25RSS

Question

Question:

Hi I bought a used one, 2005 outback 25rss, but could not find the spec. Could you find the spec? If yes please let me know Thanks

asked by: Alex

0

Expert Reply:

The 2005 Keystone Outback 25RSS has a 3,500 lb axle from what I was able to determine in my research. Therefore, if you are looking for a new idler hub you can use the Dexter Trailer Idler Hub Assembly part # 84545UC1-EZ. If you just need the bearings we have these as well, the Bearing Kit for #84 Spindles part # BK2-100.

expert reply by: Conner L

0

Answer 1

The 1998 Jayco Eagle 260FS weighs around 5,000 lbs so it is likely to have either 2,000-2,200 lb or 3,500 lb axles. If it uses 2,000-2,200 lb axles then you'll need the Bearing Kit part #BK1-100 but if it uses 3,500 lb axles then you'll need…

view full answer...

Answer 2

I recommend the BF Goodrich Commercial T/A tire LT235/75/R15/C as it will fit on a 15 x 6 wheel. These are typically traction tires and wouldn't be the best option for a travel trailer. The width of this BF Goodrich tire is 9.2 inches and 28.6…

view full answer...

Answer 3

The Camco RV Rain Gutter Extensions part #CAM42123 are universal clip on rain gutter extensions so as long as you have a rain spout that looks like the photo I have attached of the extensions installed then they will work well on your 2005 Keystone…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

view full answer...

Answer 9

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 10

I can certainly point you in the right direction. This will be a tricky one, as the Dexter 5,200 lb axles can use more than one seal size. We do not have the ability to pull an OEM build sheets to see what parts they installed at the factory so we…

view full answer...

Answer 11

Hey Jim! The Taskmaster and Westlake tires, like the Taskmaster ST235/75R15 Off-Road #TA45RR and Westlake ST235/75R15 Off-Road #WST54FR you were looking at, are made in China. A lot of people tend to shy away from trailer tires made in China but…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...