What Size Channel Does the Curt Channel-Mount Coupler part # C25328 Fit

Question

Question:

I would like the dimensions of the but end of the following product need to see if this will fit existing sleeve: Curt Channel-Mount Coupler - Squeeze Latch - 2-5/16 Ball - 15,000 lbs

asked by: Curtis T

0

Expert Reply:

The Curt Channel-Mount Coupler - Squeeze Latch part # C25328 is designed to fit channel mounts that are three inches wide inside if the channel like the Curt 3-Position Adjustable Channel Bracket part # C48610.

If your current channel measure three inches wide inside the channel this is an excellent choice.

expert reply by: Randy B

0

Answer 1

The Curt Channel-Mount Coupler part #C25328 is designed to be used with an adjustable channel such as the Curt 3-Position Adjustable Channel Bracket part #C48610 which has an inside width of 3". Therefore, the width of the but end on the…

view full answer...

Answer 2

Based on the lip on the Curt Channel-Mount Coupler - Squeeze Latch - 2-5/16" Ball - 15,000 lbs #C25328 you will be unable to use the #e98895. The #e87ZR might fit, but I would question how secure it is once again based on the lip on that…

view full answer...

Answer 3

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 4

There is no specific torque rating for securing the Titan coupler #T4853100. What you will need to do is tighten the bolts down as much as you can without crushing the metal of the coupler and trailer tongue. If you see the metal start to bend a…

view full answer...

Answer 5

For a Bulldog 180 series jack you will need replacement drop leg pin #BD500177. It includes the spring, cotter pin, and washer. You should not have to remove the inner drop leg to replace the pin and spring. Start by pulling back on the pin. Then…

view full answer...

Answer 6

The bolts for channel mount coupler #CTA-280 have the markings for grade 8 bolts. They are 5/8 inch coarse threaded bolts so the minimum torque value is 159 and the max is 212 (foot pounds). Once torqued down the force will cause the metal of the…

view full answer...

Answer 7

The Reese Strait-Line system should be chosen according to your loaded tongue weight. Ideally you want your actual tongue weight to fall in the middle of the tongue weight range of the weight distribution hitch. Since your dry tongue weight is 1,180…

view full answer...

Answer 8

I reached out to my contact at Fulton and confirmed that the Replacement 11" Long Winch Handle for Fulton Single-Speed Winches #F501101 you were looking at is the correct replacement for your older Fulton K1550. I included a video of the…

view full answer...

Answer 9

Personally I prefer the Demco Trailer Coupler #DM14976-52 with the composite handle over the Coupler #DM15791-81 with a metal handle. I feel it is easier to operate as it does not have the safety latch like you get on the metal handle. Since most…

view full answer...

What Size Channel Does the Curt Channel-Mount Coupler part # C25328 Fit

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching