Fender Replacement for Trailer that Has 12 inch Wheels and 8 inches from Edge of Tire to Frame

Question

Question:

i have a 12 inch tire that i am looking for fenders on a boat trail, . from the trailer frame to the outside of sidewall is 8 inches. the lenght is 22 inches. should the lip be pass than the sidewall of the tire?

asked by: Billy

0

Expert Reply:

For what you listed the best fender solution is the part # CE17720 as it measures 22-1/2 inches long and is 7 inches wide. Since the sidewall of the tire is tapered from the top of the tread this would match the width needs you mentioned as well.

expert reply by: Jameson C

0

Answer 1

For the set of CE Smith trailer fenders #CE19504-2 you can use existing brackets on the trailer or, if you need brackets, you can use #CE26098G-2. Drilling will be required for installation.

view full answer...

Answer 2

You can mount the fenders directly to the trailer frame through the fender skirt on the back of the fender. I would recommend using large washers if you drill through the fender skirt and attach the fender directly to the trailer frame. If mounting…

view full answer...

Answer 3

I was informed by CE Smith that you will need to use the Mounting Brackets #CE26098G-2 to properly attach the CE Smith Single Axle Trailer Fenders w/ Top and Side Steps #CE19504-2.

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 6

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 7

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 8

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 9

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 10

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 11

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...