Replacement Master Cylinder Cap for Titan Model 6 Actuator

Question

Question:

I need a new cap, whats the p/n for a replacement?

asked by: Joe

0

Expert Reply:

The Titan Zinc-Plated Brake Actuator # T4079200 is a Model 6 and the replacement cap for the master cylinder is part # T1755600.

expert reply by: Jon G

0

Answer 1

I would start by checking the condition of the Master Cylinder #T1777401 on your trailer. Using the manual activation method which I have included a image for you to understand this will check to see if the O-rings inside your master cylinder have…

view full answer...

Answer 2

The easiest way to determine what size and if you have a straight spindle is to remove one of the hubs. You will then be able to either find the numbers on the bearings to verify the correct replacement or measure the spindle diameters with a Digital…

view full answer...

Answer 3

I was unable to find an order number for you so I'm not entirely sure what you have, but were you referring to the Replacement Master Cylinder Cap with Diaphragm for Titan Model 10 and 20 Brake Actuators #T4830601? I only ask because there is not…

view full answer...

Answer 4

Orifice Connector #T1209800 is for drum brakes. It is the new style with 1/8" NPT threads. For disc brakes you would need #T4750300. Drum brakes actually do not take the larger hole. Drum brakes require around 1000 psi whereas disc brakes…

view full answer...

Answer 5

The small opening in master cylinder fittings like #T1209800 is designed to provide the proper amount of fluid and pressure through the brake lines. Bleeding trailer brakes manually is difficult. You could use a power brake bleeder, vacuum style…

view full answer...

Answer 6

Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…

view full answer...

Answer 7

The spindle dimensions are as follows: A is the mounting dimension, B is the seal dimension, C is the inner bearing surface, D is the outer bearing surface and E is the diameter of the threaded portion of the spindle for spindle nut selection. Say…

view full answer...

Answer 8

There's a few things you need to know that will tell you which hub fit your trailer's spindles. The first is your bolt pattern. I've attached a help article on measuring your wheel studs or wheels to find the bolt pattern. You also need…

view full answer...

Answer 9

People do use electric brakes on a boat trailer but it is not the best idea to do so because of the volatile relationship between water and electricity. You will need to make sure and unplug the trailer from the tow vehicle before submerging the…

view full answer...

Answer 10

In order to add electric brakes to a trailer you'll need to know the axle capacity and wheel bolt pattern. The axle capacity should be printed on a tag in the center of the beam. Once you have this you can use it to pick out the correct braking…

view full answer...

Answer 11

If you are talking about the small opening on the outside and inside of the Orifice Connector #T1209800 then those measure 0.0010" and 0.0865" respectfully. I went out to the warehouse and measured them with the digital caliper. Please note…

view full answer...

Answer 12

Disc brakes typically require about 400 more PSI than drum brakes so there is definitely a risk you'll damage your wheel cylinders on your drum assemblies. You really need to remove the orifice and replace it with the drum brake one like part…

view full answer...