Which Brophy Camper Tie Downs Can be Used with 2017 Ford F-150 with Aluminum Bed

Question

Question:

Would these work for a 6.5’ pop up camper. All aluminum truck?

asked by: Todd

0

Expert Reply:

I checked with Brophy and they recommend using the # HSSF for trucks like yours that have an aluminum bed, which will work with your truck as long as there is two inches of clearance under the lip of the bedside, as shown in the provided diagram.

For a hardware kit you would need the # TDHP.

expert reply by: Jameson C

0

click to enlarge

Answer 1

According to CR Brophy, the camper tie down brackets you'd looked at, part #HSWB are specifically designed to fit the bed of a 2019 Ford F-250 and 350. There does indeed need to be 2 inches of available space under the lip of the truck bed side…

view full answer...

Answer 2

The Brophy Clamp On Camper Tie-Downs #HSAB are a universal fit designed for full-size, non-dually trucks with a few other restrictions but you can still measure to see if they would be a fit for your F-250 based on the dimensions displayed below. We…

view full answer...

Answer 3

Thank you for the information on your 2017 Ford F-250 Super Cab! I recommend the Brophy Clamp On Camper Tie-Downs #HSWB since been test fitted and confirmed to fit a 2017 Ford F-250. The Brophy Clamp On Camper Tie-Downs #HSSF you were looking at are…

view full answer...

Answer 4

The clamp-on syle tie downs that you referenced are not a confirmed fit for your truck. If your 2016 Ford F-150 with 6-1/2' bed does not have a running boards that extend under the bed, then the TorkLift #TLF2018-TLF3007 would be a perfect fit…

view full answer...

Answer 5

In order to use the Thule TracRac SR Sliding Truck Bed Ladder Rack part #TH43002XT-508 if you have the 5-1/2' bed, part #TH43002XT-501 if you have the 6-1/2' bed, or part #TH43003XT-000 if you have the 8' bed on your 2019 Ford F-150 you…

view full answer...

Answer 6

I spoke with my contact at Brophy and they stated you'll be fine using the Brophy Clamp On Camper Tie-Downs - Bed Mount - Black Powder Coated Steel - Qty 4 Item #HSWB as long as the railing on the back of your 2008 Chevy Silverado isn't over…

view full answer...

Answer 7

According to my research, the Artis PDS1RV25 water pump is a 12 volt, 3 gallon per minute pump, and we do have the perfect option for a replacement: - Flow Max RV Fresh Water Pump #LC689052 This is also a 12 volt, 3 gallon per minute pump, though it…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 10

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 11

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...