How Much Does Class V Curt Trailer Hitch Weigh for 2003 Chevy Avalanche

Question

Question:

How much truck weight is added if I replace stock 2003 Avalanche 2500 hitch w/ Curt 2inch class 5. Cant find the weight of either one in any listing.

asked by: Steven M

0

Expert Reply:

I wouldn't know the weight of the OEM trailer hitch on your 2003 Chevy Avalanche but I can say that the Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2" # C15324 weighs in at about 45 lbs.

Please note that while this does have higher weight ratings of 16K Towing/2.4K Tongue and 17K Towing/2.4K Tongue (with weight distribution) if the weight ratings of your Avalanche are lower then you will still be limited by that number.

expert reply by: Jon G

0

Answer 1

The highest capacity 2-inch hitch we offer for this vehicle is the Curt Class V Receiver Hitch #C15324. This bolt-on no-drill hitch is rated for 16K towing and 17K towing with weight distribution. There are no 5th wheel installation kits for the 2004…

view full answer...

Answer 2

Curt, Reese and Draw Tite are all great hitches, so it often comes down to preferences. For some vehicles it may make more sense to go with one brand over the other based on design, but for your 2004 Chevy Suburban 2500 the Curt Hitch part #C15324…

view full answer...

Answer 3

I do have a solution, but we do not have either of the Draw-Tite hitches. Instead, I recommend the Curt Trailer Hitch Receiver #C15324 for your 2004 Suburban. This is also a Class V hitch. It has an even higher capacity when compared to Draw-Tite…

view full answer...

Answer 4

Weight distribution is a good idea any time the loaded trailer weighs 50 percent or more than the vehicle. In this case, at 6,200 pounds gross trailer weight, the trailer does way more than 50 percent of the vehicle so weight distribution is a good…

view full answer...

Answer 5

The Curt #C15324 you mentioned is a great choice for your 2004 Chevy Avalanche, but it might be a bit overkill as a Class V hitch since it's not going to give you a higher towing capacity; it would be more peace of mind than functionality so…

view full answer...

Answer 6

When it comes to upgrading your class 2 trailer hitch on your 2005 Coachmen Cross Country I recommend The Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2 inch #41990-07. This trailer hitch welds onto the frame of…

view full answer...

Answer 7

I spoke with our installers and they told me that this will happen time to time. They said there are times when the auto manufacturer will have the holes moved just a bit, but they work with them to make it work. They told me that they use a tool…

view full answer...

Answer 8

Your standard grade 5 half inch coarse threaded bolt has a clamping force of around 9,000 or more pound force and a 1/2 inch grade 5 coarse threaded bolt has a tensile strength of 120,000 pounds per square inch. This means one 1/2 inch grade 5 coarse…

view full answer...

Answer 9

The first thing I recommend is to check out the towing capacity of the hitch you have installed on your 2005 Chevrolet Avalanche 1500 4 X 4 . You will want to make sure the hitch is rated to be able to use a weight distribution system and you do not…

view full answer...

Answer 10

Basically they are the same connector with just a slightly different part number. We carry the part #HM40975 and if you ordered the 40974 from someone else (not recommended haha) you'd get the same thing which just a different part number on the…

view full answer...

Answer 11

In the attached picture, the mounting holes are noted. According to the installation directions for the Curt #31302 hitch, you will have to remove your tow hooks on your 2003 Chevy Avalanche Z71, which will be the 2nd hole needed for installation. I…

view full answer...

Answer 12

In 2003 there was a design change in the frame of the Chevy Express Van which consequently affected the ability to install a front mount hitch in the vehicle. The last year that there was a front mount trailer hitch available for that vehicle was…

view full answer...