Recommended Axle Lift for 2007 R Vision Trail Cruiser 30QBSS Travel Trailer

Question

Question:

Hello, We have a 2007 R Vision Trail Cruiser 30QBSS Travel Trailer that rides very low and we have actually scrapped our Sewage Connector and broke one of the back jacks on the trailer. We are not sure what lift kit would work for our trailer. Based on the weight of our trailer i think Item # K71-724-02 would be the correct one. Can you please help us determine what product we would need? Thank you!

asked by: Cody B

0

Expert Reply:

Your 2007 R Vision Trail Cruiser has Dexter Torflex torsion axles. Based on your GVWR it is likely you have #10 Torflex axles that have a center to center mounting of 8 inches on your trailer frame. If this is accurate then you will use the lift kit # K71-707-02. This is for axle capacities from 2,300 to 4,000 lbs each.

Based on the GVWR of your trailer I'm fairly confident this is the correct fit for you over the larger axle lift # K71-724-02 you mentioned.

expert reply by: Jason S

0

Answer 1

Most likely the lift kit you need is the part #K71-707-02 that you referenced which fits number 10 TorFlex axles like we are almost certain you have but I recommend finding the label on the axle which has the capacity/info listed and verifying that…

view full answer...

Answer 2

It definitely sounds like your 2004 R-Vision Trail Lite has number 10 axles based on the dry weight and info I can find on that trailer. I recommend you get the Torflex Lift Kit - Tandem Axle - 2-5/8" Lift #K71-707-02. The other axle sizes are…

view full answer...

Answer 3

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Recommended Axle Lift for 2007 R Vision Trail Cruiser 30QBSS Travel Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching