Adapter to Get Third Brake Light Circuit Isolated for 2019 Dodge Ram

Question

Question:

How to hook up a brake light on my 2019 Dodge Ram? Can. You help?

asked by: Russell S

0

Expert Reply:

You can use the third brake light module part # PP20-702 to get a dedicated brake signal from either your trailer wiring or the vehicle wiring. Since the stop lights and turn signals on trailer wiring are on the same circuit you can use this adapter to convert the wiring to just a stoplight signal which you can use for powering a third brake light.

expert reply by: Jameson C

0

Answer 1

The running light/brake light on your salter should have a wire ran to it for the brake light and one for the running light. You'd want to use the #PP20-702 to isolate out the brake light like you need to run to the stoplight circuit of your…

view full answer...

Answer 2

The logic box that you are asking about is our Pacer Performance 3rd Brake Light Logic Module #PP20-702. This is a piece of equipment that is required when using an LED light as a 3rd brake light. If there is a specific light style that you are…

view full answer...

Answer 3

The Pacer Performance 3rd Brake Light Logic Module part #PP20-702 is your best option to isolate the brake signal from the turn signal for a third brake light. However, the issue that you are experiencing is that some LEDs simply don't draw…

view full answer...

Answer 4

If you absolutely do not want to splice into the vehicle you could use the trailer connector to power the third brake light on a truck bed camper but the issue with using the trailer connector is that the stop/turn circuits are combined. Therefore,…

view full answer...

Answer 5

For your 2013 Hyundai Santa Fe, all trailer wiring harnesses will give you the combined wiring. This is the traditional configuration for all trailer connectors. Then to separate the wires on your trailer you will use #PP20-702 which will work well…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...