Replacement Heater Wiring Harness for Thomas Payne Theater Seating

Question

Question:

I have a 2017 Keystone Montana 3950BR with Thomas Payne heated theater seats. The remote is Lippert part number 372795. On your website, it is Item # 195-000050. I need the wire that is between the remote and the power supply. It has the female connection that the remote wire plugs into and the jack for the power supply to plug into. It also has a quick disconnect that connects to the heater wires. The wire has broken at the strain relief on the female connector.

asked by: Cliff H

1

Helpful Expert Reply:

I spoke to my contact at Lippert and we were able to determine that you need the Replacement Theater Heating Seat Kit part # 195-000113. I have attached a photo of this part for you as well. If this is not what you were referring to then please send me a photo of what you have and I will see if we can do a better job of getting you the correct replacement part.

expert reply by: Conner L

1

click to enlarge

Answer 1

I spoke with my contact at Lippert who said that there is a notch in the side of the cup holder that you should be able to feel with your hand. Once you find it you will need to use a flathead screwdriver or a butter knife to pop it up. This will…

view full answer...

Answer 2

I spoke with the manufacturer, MORyde, and the MORryde Manual Storage Reel for 30' Long Power Cords - 13-7/16" Tall #MR77RR has a shipping weight of 16lbs, product actually weighs 15lbs.

view full answer...

Answer 3

It sounds like you've got a Thomas Payne Seismic Dual Power Reclining RV Loveseat w Console, Heat, Massage, LEDs like the #195-091-092-090, and you need the power plug for it. In this case you'll want to use the Replacement Power Cord with…

view full answer...

Answer 4

I confirmed with Progressive Dynamics that the replacement part you need is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V.

view full answer...

Answer 5

I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and under…

view full answer...

Answer 6

The recliners run off of 110V AC, using a standard 110V outlet. So, if your camper doesn't already have a power inverter you could use one like the Go Power #34280176. If your loveseat is a Thomas Payne model, you can use the #195-387595…

view full answer...

Answer 7

Since most trailer manufacturers do not make wheel and tire information available to the general public, it is hard for me to tell you what size lug nuts you have on the wheel. I can tell you they do have caps over them. The most common size of lug…

view full answer...

Answer 8

Try removing the good working cupholder and installing it on the side that isn't working. Most likely that will fix the issue and indicates that you need a new cupholder like with the part #195-387597 that you referenced.

view full answer...

Answer 9

Though we don't carry that exact part, we do have a strut with the same dimensions that is likely to work. Based on my research the gas strut 654150 is 26.46" when extended, has two metal ends and is 120 lbs of force. The strut we carry…

view full answer...

Answer 10

If you need to remove one of the cup holder assemblies on your Thomas Payne Momentum Recliner you can do so by first locating the notch on the side of the cup holder that you should be able to feel with your hand. Then it's just a matter of using…

view full answer...

Answer 11

You could test the wiring of the heating pad with a circuit tester like the part #PTW2993 to see if there is voltage to it when the heating function is on. If you are getting voltage but the seat isn't heating you'd want to replace the heater…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Heater Wiring Harness for Thomas Payne Theater Seating

Product Page this Question was Asked From

Continue Researching