4" Tall x 32-3/4" long ramps work in conjunction with 56" or 67" Race Ramps to provide clearance on opposite end of vehicle. They also allow standard floor jacks to fit under a low-profile vehicle. Fit tires up to 12" wide.
Features:
Specs:
Race Ramps Roll-Ups can be used to lift the front or rear of your vehicle 4" off the ground. They are designed to work in conjunction with 56" or 67" XT Race Ramps to provide additional clearance on opposite end of your vehicle. Additionally, with 4" of lift, the Roll-Up ramps will allow most standard floor jacks to fit under your low-profile vehicle. The ramps have an 11.9 degree angle of approach, which allows you to lift a low-ground-clearance vehicle without worrying about scraping its front end.
These ramps are made of ultra-strong, solid core, high-density EPS foam that won't crack or bounce. Each ramp supports 1,500 lbs - giving you a total weight capacity of 3,000 lbs for lifting a vehicle for service or display. The ramps are lightweight, weighing no more than 4 pounds per ramp, so you can transport and store them with ease.
The ramps are covered with a textured coating and are flat on one side. This keeps them from skidding when you drive up on them. The coating is a hybrid polyurea compound that is resistant to water and other automotive chemicals commonly found around the garage. And although this coating is durable, it will not scratch, mark, or scrape your garage floor or the ground.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to look at the Race Ramps Roll-Up car ramps. This is for a quantity of two of them. Now, these are double-sided ramps that can provide an extra 4" of lift. These are designed to work with race ramps 56" or 67" car service ramps. This is a set of two roll ups which will give you even more clearance for working under your low to the ground car. These rolls up can raise the front or the rear of the car to allow you to slide a standard floor jack in where, otherwise, it wouldn't fit. They're 14" wide, so they can be used with tires up to 12" wide.
They do weigh only about four and a half pounds each. They're small enough to even fit in the trunk of your vehicle. Each ramp will hold 1500 lbs for a total weight of 3000 lbs for the two of them. These are 100% solid. They're made with a high density expanded polystyrene that is coated with a hybrid polyuria. This patented process will result in a product that is extremely lightweight, yet strong and durable.
These ramps, when they're put down on the floor, they will not slide, scratch or otherwise damage any floor type. They are made in the USA. The dimensions on these: overall length, they are 33" long, they are 14" wide, 4" tall. The slope on it is a 12 degree slope and the top part is flat about 8" wide. But that should do it for the review on the Race Ramps roll up car ramps for the quantity of two.
Average Customer Rating: 5.0 out of 5 stars (2 Customer Reviews)
4" Tall x 32-3/4" long ramps work in conjunction with 56" or 67" Race Ramps to provide clearance on opposite end of vehicle. They also allow standard floor jacks to fit under a low-profile vehicle. Fit tires up to 12" wide.I purchased these as an accessory to a pair of full drive up ramps that I've had for over 5 years. they are second to none.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.