Ventline Ventadome Trailer Roof Vent Mounting Hole Measurements

Question

Question:

Can you tell me the distance of the bolt pattern? I only have 15 between roof braces. Also, do you sell a smaller vent? Thanks

asked by: Bill

0

Expert Reply:

The Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White # V2092SP-28 is the standard vent size. It is not uncommon to have roof braces that are 15 inches apart. This vent has mounting holes that measure 15-1/4 and 15-3/4 inches on center. I've attached a photo of the measurements I took for you.

I recommend the Installation Kit # 344270KITW for the installation of your roof vent. I've attached a video to assist.

We do not carry roof vents of any other size unless you drastically change the style to # VP-543SP or # 9106-2756.

expert reply by: Jason S

0

click to enlarge

Answer 1

Since heat rises I would at the very least put a set of the Trailer Vents #HMAV2-AVT2 near the top of the trailer to get the hottest air of the trailer out. What you could do for maximum air flow in your trailer is have a set facing forward in the…

view full answer...

Answer 2

Having already done adjustments and replaced multiple parts, you've really ruled out potential mechanical causes here. A next step would be to look at the electrical side of things. Specifically I would look at connection points in the wiring on…

view full answer...

Answer 3

It sounds like your new tandem axle trailer has a surge brake coupler. You will need to use the manual lockout on the coupler if there is one or add a Replacement Solenoid Valve for Titan Brake Actuators with Reverse Lockouts #T4748800. This electric…

view full answer...

Answer 4

Brake magnets such as the Replacement Magnet Kit #AKBRKR-M12 on trailer electric brake assemblies are non-polarized. When installing an electric brake assembly, like the Right Hand 12" #AKEBRK-7R-SA, either wire can be used for the brake signal…

view full answer...

Answer 5

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 6

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 7

I have a solution for you but there isn't just a replacement converter section for the Elixir ELX-45. You're going to need to replace the entire panel with the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger item…

view full answer...

Answer 8

WF-8735P is a 35-amp panel model. To upgrade to a lithium ready system you will need the Progressive Dynamics #PD4135K Converter/Smart Charger rated for 35-Amp. this system includes a high voltage output to provide full, quick charge for your lithium…

view full answer...

Answer 9

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 10

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 11

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 12

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...