Length of Drive Shaft From Repair Kit for Venture Lead Landing Gear Leg

Question

Question:

Im wanting to know the length of the shaft Item # LC146059 ?

asked by: Dennis R

0

Expert Reply:

I went out to the warehouse and measured the drive shaft of part # LC146059 for you. The total length was about 6-3/8 inches. Between the two closest holes on the end I measured about 1 inch and then from the middle hole to the furthest it's about 4-1/2 inches.

expert reply by: Charles S

0

click to enlarge

Answer 1

Yes, I attached a diagram you can use to install the #LC146059 that you referenced.

view full answer...

Answer 2

It sounds like you're looking for the lead drive shaft pin on your landing gear leg and if that's the case we do carry this but it comes in a kit with a few other parts, the Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear…

view full answer...

Answer 3

Though I could not find anything about the T46059 repair kit you referenced, but odds are the jack isn't rated high enough for the weight of your trailer. Or there is more than just the gears that need to be replaced. What you will probably want…

view full answer...

Answer 4

The Lippert Components Lead Leg Repair Kit #LC146059 and the Stromberg Carlson Kit #LG-146059 referenced in your question are essentially the same kit. I went out to our warehouse to verify this. It is actually not too uncommon for landing gear…

view full answer...

Answer 5

I reached out to my contact at Lippert regarding the issue you're having with the landing gear on your trailer and something jumped out at him right away as being the most likely culprit. He noticed that the voltage you checked at the battery was…

view full answer...

Answer 6

Thanks for the pictures! Based on the part number of your motor it appears you have Venture landing gear. As such you will likely need follow leg rebuild kit #LC146060 or lead leg rebuild kit #LC146059 to fix your landing gear. Landing gear legs are…

view full answer...

Answer 7

It sounds like you might have an Ultra-Fab landing gear set. I have included a diagram showing how the system gets wired. On it the white wire is the power wire and the green wire is the ground.

view full answer...

Answer 8

In order to know which lead jack repair kit is the right one you do need to know who the manufacturer of the landing gear is on your Jayco Eagle. If you have Lippert Components, Venture or Stromberg Carlson landing gear you can use Lead Jack Repair…

view full answer...

Answer 9

The larger gear of the #C37ER has an inner diameter of .587 inch and the smaller gear has an inner diameter of right at 1/2 inch.

view full answer...

Answer 10

For your 2010 Open Range 5th-Wheel Trailer, I recommend looking at the Stromberg Carlson Electric Landing Gear Set #LG-4. Each leg on this set is 33-1/2 inches tall and provides up to 19-7/8 inches of travel. It has a combined weight capacity of…

view full answer...

Answer 11

Thanks for the photo as well as the description you offered. The Follow Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146060 is the correct fit for your 2010 Coachmen Brookstone 341RE.

view full answer...

Answer 12

I spoke with my contact at Lippert Components about what the correct replacement bevel gear kit would be for the front landing gear on your 2017 Open Range Roamer 371MBH. He said that the front landing gear for the Ground Control 2.0 actually…

view full answer...

Length of Drive Shaft From Repair Kit for Venture Lead Landing Gear Leg

Product Page this Question was Asked From

Continue Researching