Troubleshooting Husky Brute Electric Trailer Jack That is Clicking

Question

Question:

My jack worked fine last time I used it now it just clicks when I push the toggle up or down. It start moving very slowly a couple of times but then stops. I checked the battery it was good. I replaced the connector to the battery as it was corroded. Still only clicks.

asked by: Steve

0

Expert Reply:

If your Husky Brute Electric Trailer Jack is only making a clicking noise and you have checked the power source there are a couple of other issues that may be occurring. Start by checking your ground connection to ensure it is secured to a clean, bare metal surface free of any type of paint or corrosion. The other issue may be that you have a bad switch that needs replacing. (Try electronic shop for replacement.)

It is also possible that the jack was overextended or retracted and there has been damage to the nut and screw and at that point your only option would be to replace the entire jack.

I think the best value for an A-frame tongue jack is the Stromberg Carlson # SC63VR which is rated for 4500 pounds of tongue weight. This is 1000 pounds more than other models, and even though you may not need this much capacity, you will find that the jack motor runs quick and effortlessly. This will add years to its life. This jack also has a unique clutch that prevents damage from overextending or retracting the jack foot - the most common reason for jack failure. I also like that is has a generous 23" lift, including a time-saving drop-foot. It includes LED lights for operating the hitch in the dark, and a built-in bullseye leveling bubble.

expert reply by: Kyle S

0

Kevin O.

6/6/2020

I am having the same issue. The clicking got worse to the point it stopped moving. I pulled the cover off and when I pushed in on the relays, it works. Tried it both up and down while pushing the relays in. Let go of the relay, and it stops moving, and back to the clicking. So the clicking is either a bad connection to the board or the relays are bad. I'm leaning towards the board separating. I tried soldering them back to the board, but no help. So is the circuit board available?

Reply

Chris R.

6/10/2020

Unfortunately the circuit board isn't available as a replacement part - we've actually checked with Husky before on this. If it's still under warranty you can try reaching out to them, otherwise the whole jack will need to be replaced.

Reply

Kevin O.

6/10/2020

@ChrisR Thanks for your reply. If you are good with a soldering iron, you can buy new relays and replace the old ones. I did confirm that it is the relays and not the board. I have 2 relays on the way.

Reply

Christian D.

5/20/2020

My jack is getting worse and worse. I redid all my connections, ceck my ground connection. Still only clicks. However, in manual mode, the electrical system works both on the remote control and directly on the jack.

Reply

Chris R.

5/22/2020

Have you checked the power source/battery itself? I wonder if the battery isn't fully charged or in less-than-perfect condition. Check to make sure it doesn't need charging or replacement.

Reply

Nick H.

5/22/2020

@ChrisR Do you sell replacement batteries?

Reply

Chris R.

5/22/2020

@NickH We don't have batteries available but they're easy enough to find at a local auto shop or home goods store.

Reply

Answer 1

A common problem with a trailer jack like your Husky Brute that will not go up or down is that the battery is dead or bad or the battery connection is bad. I would start by checking the battery and the connections, including the ground. If it's…

view full answer...

Answer 2

Since you have already tested the switch and found it to be defective it will need to be replaced. The original part is no longer available, but could potentially be sourced through an electonics supply store. If the jack has more problems and must…

view full answer...

Answer 3

When choosing a jack for your trailer, you will want to keep in mind that the jack only needs to lift the tongue of the trailer. It will not need to support the weight of the entire trailer. After doing some research on your 2008 Starcraft 34RT, it…

view full answer...

Answer 4

If your Husky Brute 4500 isn't extending or retracting properly then I recommend using the manual override to see if it's something internal or if it's an electronic part of the jack. For a replacement electrical part you'll need to…

view full answer...

Answer 5

This type of question is always challenging due to the amount of varying opinions, different experiences, and lack of controlled environment with set standards. Please keep in mind that Castle Rock is an economy trailer tire so they will not perform…

view full answer...

Answer 6

It sounds like you're asking about the 12V circuit on the 7-way trailer connector on the rear of your 2003 Chevrolet Trailblazer. Some vehicles will always have power and some others will not. We don't have this specific information for your…

view full answer...

Answer 7

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 8

The #ETBC7 brake controller installation kit for the Prodigy P2 #90885 includes multiple circuit breakers of different current ratings to allow for use with one, two or three-axle trailers. More axles and/or more powerful brakes will require more…

view full answer...

Answer 9

We actually have a version of the #ETBC7 that we put together specifically with the Curt Echo Mobile brake controller part #C51180 in mind with the #ETBC7L which comes with just the components needed for the Echo. The ETBC7 comes with the same…

view full answer...

Answer 10

The longest pigtail (portion that connects to tank) that we carry is 5 feet with part #100575-60-MBS. Then for an automatic changeover that each tank attaches to you'd want the part #CAM59005. I attached a link to a page that has more info on…

view full answer...

Answer 11

I took a look at the online owner's manual for your 2005 Dodge Durango. It states that all 2005 Dodge Durango trucks are intended to tow trailers of up to 2,000 pounds without any added equipment or alterations to the standard model. It goes on…

view full answer...

Answer 12

I have a replacement jack option for you, but the lower jack assembly 87460 you mentioned for your Husky Brute Jack HB4500 has been discontinued as it was for the older model jacks. Since your lower jack assembly is damaged you will need to replace…

view full answer...