Is there a Grommet for Peterson Clearance Light # M152A

Question

Question:

where can I find 152 A grommet?

asked by: Ross

0

Expert Reply:

For a rubber grommet that will fit the Peterson clearance light # M152A you can use # A91GB. If you are looking for the plastic base we do not carry that particular model and in that case I recommend switching to light # A91AB and using bracket # A91BB with power wire # A91LW (the light grounds through one of the mounting screws with this light and bracket combination).

expert reply by: Michael H

0

Answer 1

Sealed, Miro-Flex, Thin Line, LED Trailer Marker Light #MCL63AB does indeed have the 2 prongs at the center on the back of the light. I have included a picture showing this for you.

view full answer...

Answer 2

To install the part #MC65AB you would want to use the bracket with wiring part #A65PB which has a power wire but then grounds through the mounting hardware. If you have a ground wire on your current fender setup you can run the ground wire to the…

view full answer...

Answer 3

We do have red trailer clearance lights that are 2-1/2" x 1", and what you will need is the following: - Thinline LED Clearance and Side Marker Light w/ Chrome Bezel #MCL-91RK

view full answer...

Answer 4

The “SAE P2PC 98” you provided is a code used by the department of transformation and will not have any bearing on the correct replacement. In order to determine the correct replacement I would need you to either A) remove the lens and find the part…

view full answer...

Answer 5

It's kind of hard to tell exactly what lights will work for your 1996 Tiffin Allegro, but I think something like the 2-1/2" x 1-3/16" Thinline LED Clearance and Side Marker Light #AL91AB should do the trick. If your lights have…

view full answer...

Answer 6

I believe the Clearance Light part #MC65RB would be the correct light for you. The difference in length is about .1 of an inch which would be close enough. Especially since these look exactly like what you have and the other dimensions match up. The…

view full answer...

Answer 7

To find the right replacement lens and bulbs for your 2006 Pace Journey, we will need to know what lights you have. You will want to take the lens off and check the housing of the light itself. The numbers on the lens will not be for the light. Many…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...