Optronics Sealed Thin Line Two-Bulb Trailer Clearance Light Installation Video

To find the right replacement lens and bulbs for your 2006 Pace Journey, we will need to know what lights you have. You will want to take the lens off and check the housing of the light itself. The numbers on the lens will not be for the light. Many…

I can certainly understand wanting to be able to piece together parts of the lights to try and get some cost savings, but the white base alone of the Bargman Trailer Tail Light #30-92-004 is not something that is made available as a standalone part.

Based on your picture it looks like the left side is #30-92-004 and the right side would be #30-92-002. These lights are 8-9/16 inches across, 4-9/16 inches tall, and 2-1/8 inches deep. Just for reference on the wiring, since you can't always go…

For the clearance light part #AL91RB we have the grommet part #A91GB which is basically a hard rubber.

We can get you all the lights you need though it will come in the form of different parts because there isn't a specific "kit" containing everything. For the stop/turn/tail lights you can use the GloLight LED Trailer Tail Light…

Usually a grommet-mount incandescent tail light will be pressure-fitted into the grommet and held there simply by friction from the rubber. If there are no visible screws to allow lens removal and no accessible portion of the light's rear surface…

You can use the Miro-Flex ThinLine LED Trailer Clearance or Side Marker Light - Sumbersible - 4 Diodes - Red Lens #MCL63RB which is 4" long and 1-1/4" tall with 3" spacing between the mounting holes. I've also linked our entire…

We actually have a handy help article, linked to the right for you, that explains this and other helpful information on trailer lights. Below is an excerpt: The light beam emitted from a P2 or P3 light spreads out 45 degrees to each side of its…

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

A trailer light that only has 1 wire means that it grounds through its mounting hardware. The single wire is the power wire. The best surface to ground a light to is steel. If steel is not available in the area the light installs you can attach a…

I can certainly point you in the right direction. Looking at these 2020 Grand Design Imagine campers, the clearance light appears to be very similar to the Optronics #MCL0032ABB. This is a 4" long 2" tall and 1" thick amber clearance…

I recommend using the Optronics Trailer Clearance or Side Marker Light w/ Reflex Reflector - Incandescent - Red Lens #MC44RB, which has mounting holes 3" apart like your existing lights and will be 4" long x 1-1/2" wide. These are an…