bing tracking image
Q & A Icon

Troubleshooting Brake Controller on 2002 GMC Sierra 2500 HD  

Question:

The electronic controller in my 2002 GMC HD 2500 truck stopped working. I tested the voltage sent to the controller and no juice goes through when the brake is pushed. I replaced the switch for the tailights. Is there a specific fuse for the brake controller or a relay? I have gone through the fuse box and cannot seem to find it.

0

Expert Reply:

First, use a circuit tester like part # PTW2993 on the black wire exiting the rear of the controller to verify that power is reaching it. If not, there is a 20- or 30-amp fuse in the power distribution box, located under the hood on the driver's side fender, that is most likely blown. Once the fuse is replaced, you will want to inspect the brake output circuit on the trailer connector, tracing it back to the trailer brake magnets to determine what caused the fuse to let go. Skipping this step will probably mean you will keep blowing fuses.

Will the controller actuate the brakes when the manual override switch is activated? If the brakes work with the switch, but not the brake pedal, there is a different fuse involved. Check your owner's manual for the location of the CHMSL fuse, and check and replace if needed.

You can see additional photos at the links provided.

expert reply by:
0
Mike L
click to enlarge

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>