What Else is Needed to Install Tekonsha Voyager 39510 on a 2008 Ford F-150 with Tow Package

Question

Question:

I have a 2008 F-150 with tow package, 4.6L, smaller V-8. If I get the Tekonsha 9030, what else do I need?

asked by: Phil

0

Expert Reply:

You will also need the wiring adapter, part # 3035-S. One end of the adapter would plug into the port under the dash, while the bare leads would attach to the leads coming off of the brake controller.

expert reply by: Mike L

0

Answer 1

The connector for installing your brake controller is located under the dash. Directly under the steering column, you will see the diagnostic port. The port for the controller is located above and behind, as you can see in the photo I've…

view full answer...

Answer 2

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 3

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 6

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

Hey Cynthia, thanks for reaching out! We've got the Draw-Tite Class IV #75506 and the Draw-Tite Class V #41933 that fit your 2006 Ford F-150 STX as long as it doesn't have the factory hitch. I've attached some installation videos of these…

view full answer...

Answer 10

It sounds like when the Redarc Tow-Pro Elite Brake Controller #RED44FR was installed on your 2022 Toyota Highlander that they may have damaged the brake signal wire or tied into the wrong wire. I recommend taking it either back to the shop who…

view full answer...

Answer 11

We have a really great kit that comes with everything you'd need to convert your 2021 Vanleigh Pinecrest 335RLP from tandem 6k drum brakes to electric over hydraulic disc brakes with the HydraStar Disc Brake Kit w/ Actuator for Triple Axle…

view full answer...

Answer 12

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

What Else is Needed to Install Tekonsha Voyager 39510 on a 2008 Ford F-150 with Tow Package

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching