Are Aluminum Load Resistors for LED Trailer Lights Submersible
Question:
Are these submersible?
asked by: Ken
Expert Reply:
Load resistors like # DI34ZR that are sometimes needed for LED-type trailer lighting are sealed when manufactured but they are not intended to be submersed in water.
The best way to install load resistors on a trailer whose LED lights need them for proper operation with the vehicle wiring is to use a junction box like # 38656 or # HS381-9000 mounted up near the trailer's tongue area. This will protect the resistors from damage that could occur if they were to be submersed while hot.
You'd then want to run your wiring for the LED lights from the junction box back to the lights using wire such as # 16-4B-1.
Often users disconnect their trailer wiring connector from the vehicle before backing the trailer into water.
Products Referenced in This Question
Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Wiring
- Hydrastar
more information >
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Shop: LED Backup Light for Truck or Trailer - Submersible - 10 Diodes - Oval - Clear Lens - Qty 1
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Shop: Trailer Wiring Junction Box
- Shop: Trailer Wiring Junction Box - 7 Color Coded Terminals - ABS
- Video: Optronics Trailer Lights - Tail Lights - BUL10CB Review
- Video: Spectro Trailer Wiring Junction Box Installation
- Video: Review of Putco Light Parts - LED Bulb Aluminum Load Resistors - P230004A-2
- Video: Review of Diamond Lights - Load Resistors - DI34ZR
- Search Results: 38656
- Search Results: e99011
- Search Results: led load resistor
- Search Results: load resistors
- Q&A: Solution for Strobing LED Lights on Rebuilt Trailer with VW Caddy
- Q&A: Are Load Resistors Required When Installing LED Lights on a Trailer
- Shop: GloLight LED Backup Light for Truck or Trailer - Submersible - 22 Diodes - Clear Lens
- Video: Review of Optronics Trailer Lights - GloLight Backup Light - BUL111CFPG
- Q&A: Wire Gauge and Ground Locations for LED Running Lights on a Trailer
- Q&A: How Does Trailer with 7-Way Wire to Reverse Lights
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Trailer Wiring Diagrams
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Shop: Trailer Wiring
- Search Results: 68149
- Video: Choosing the Right Brake Controller
- Shop: Trailer Hitch
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation