Are Load Resistors Required When Installing LED Lights on a Trailer
Question:
Will I need a equalizer module or any other device to add this light to an existing trailer with std. 12 volt bulb lights??
asked by: John
0
Expert Reply:
You will not need to add any diodes or other modules to prevent hyperflashing or any other bizarre taillight behavior when you install this Optronics Tail Light # STL78RB on your trailer.
If you were installing LED tail lights on a vehicle and replacing the lights on the turn signal circuit then you would need a load resistor so that the blinkers would function correctly.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Search Results: trailer lights
- Search Results: rv drinking water hoses
- Shop: Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Video: Hollywood Racks LED Light Bar Review
- Q&A: Is Saris SA3032 1-1/4 to 2 inch Hitch Adapter Threaded for Hitch Pin
- Q&A: Size of Bolt in Saris Replacement Aluminum Hitch Adapter Sleeve # SA3032
- Q&A: Why is There Two Holes on One Side of Saris Aluminum Hitch Adapter Sleeve and One on Other Side
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 13" to 15" - 5 on 4-1/2 - PreGreased
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Video: Review of etrailer No Extension Receiver Adapter 2" To 1-1/4" - e63YR
- Video: etrailer Trailer Hitch Receiver Adapter Review
- Video: Review of etrailer 2" To 1-1/4" Receiver Adapter With 4" Extension - e58YR
- Q&A: Length and Hole Size/Spacing for Replacement Aluminum Adapter Sleeve for Saris Bike Racks SA3032
- Shop: Replacement Aluminum Hitch Adapter Sleeve for Saris 1-1/4" Hitch Bike Racks
- Shop: Thule Replacement Aluminum Shank Adapter - 1-1/4" to 2"
- Shop: Saris Freedom Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Shop: Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 15 Diodes - Red Lens
- Shop: Camco RV and Marine Disposable Water Filters - KDF/Carbon - Qty 2
- Search Results: 34823
- Search Results: mcl95rb
- Video: Review of Mount-n-Lock RV Cargo Carrier - Replacement RV Bumper - MNT43VR
- Q&A: 4-Pole Trailer Wiring Functions & Wiring Installation for Optronics Oval LED Trailer Light STL78RB
- Video: Review of HE Parmer Trailer Fenders - No Step - HP69VR
- Video: etrailer Trailer Hubs and Drums - Hub - AKIHUB-545-2-G-EZ-1K Review
- Q&A: Hitch Bolt for Saris Bike Rack with 1-1/4 Inch Shank Using 2 Inch Receiver Adapter
- Shop: Trailer Wiring
- Search Results: spring seats
- Search Results: #84 spindle
- Search Results: tail light conversion kit
- Shop: Brake Controller