Recommended Weight Distribution System For 2004 Fleetwood Pioneer Travel Trailer

Question

Question:

Hello, I have a 2013 F150 and a 2004 Fleetwood Pioneer 18t6 travel trailer. I am looking into a weight distribution hitch but Im not sure which one to get specifically with the tongue height I have. My hitch receiver sits about 18.5inch to the top above the ground. When I used a standard 2inch / 3/4inch rise ball mount, the trailer tongue points down low quite a bit mostly because the ball is too low. I saw the Reese 49902 and it has a 5.5inch rise which might be ok but if it isnt enough, I think I would have to buy another shank which is very expensive.

asked by: Alex J

0

Expert Reply:

For the limited clearance you described, I don't recommend the Pro Series Weight Distribution System w/ Friction Sway Control - Round - 10,000 lbs GTW, 750 lbs TW # PS49582.

For your system, you need to take the total tongue weight which includes the loaded trailer tongue weight and any cargo behind the rear axle of your tow vehicle. This combined number is the total tongue weight and you want that to fall near the center of the tongue weight rating of your weight distribution system.

For your system I recommend the Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion # FA92-00-0800. This system is rated for 0 to 800 lbs tongue weight and will give you better ground clearance as well as sway control that is far superior to the friction bar. This system utilizes metal on metal friction on both sides to consistently control sway. You will need a hitch ball and I recommend the 2 inch diameter # A-90 or # 19286 for a 2-5/16 inch option.

I've attached an article to help you determine the rise you need. This is very similar to finding the correct ball mount.

expert reply by: Jason S

0

Answer 1

I would be happy to help! The Curt T-Connector #C56347 and #C89KR you were looking at are both confirmed to fit your 2012 Kia Sedona and will both give you the 4-way connector you need. There is not major difference between the harnesses so I…

view full answer...

Answer 2

The towing capacity of a 2017 Kia Sedona (All Models) is 1,000 lbs for trailers without brakes or 3,500 lbs for trailers with brakes. The Starcraft Satellite16KS does have electric drum brakes so you will be good to go but just be careful how much…

view full answer...

Answer 3

1. Normally I'd say that your 2016 Kia Sedona would be just fine as long as the pop up has brakes, but since your towing capacity without brakes is only 1,000 lbs it would be a good idea to install one. As far as the warranty is concerned you are…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...