Available Lengths of Erickson E-Tracks

Question

Question:

Is 8ft the longest length these come in. I really need a couple of 10 ft and a couple 6 foot lengths.

asked by: Tommy A

0

Expert Reply:

Unfortunately, 5 feet is the longest Erickson e-track we carry and is # E19148. They also come in 2 foot # EM59150 and 4 foot # EM19147 lengths. They can be cut to the needed length.

expert reply by: Charles S

0

Answer 1

The Erickson Horizontal E-Track, part #E19148 has 1/4 inch diameter mounting holes spaced 2 inches apart. The screws you use should be at least long enough to go 3/4 inch into the wood you are mounting the track to. The more screws you use the more…

view full answer...

Answer 2

Yes, you can use Erickson Horizontal E-Track item #E19148 as front straps to hold down a car. These tracks have a 2,000 lbs maximum capacity per track. You will want to use the etrailer E-Track Backing Plates w/ Hardware item #e96RR for mounting. The…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 6

You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…

view full answer...

Answer 7

The etrailer E-Track Roller Idler #e67HR is 3" from the top of the e-track to the bottom of the roller.

view full answer...

Answer 8

The Bulldog Winch Ratcheting Wheel Tie-Down Strap #BDW20362 is designed to connect to a D-Ring type of connection point so you wouldn't need to install an e-track on your trailer. For your application I recommend installing the Brophy D-Ring Tie…

view full answer...

Answer 9

Yes we do have backing plates for the e-tracks. I recommend going with etrailer E-Track Backing Plates w/ Hardware - Galvanized Steel - 6" Long x 6" Wide - Qty 4 #e66RR which is a nice kit that includes 4 plates and all the necessary…

view full answer...

Answer 10

E track like the part #E19148 (5 foot section) would work well for what you are looking to do. People use E track for car haulers all the time and it works well. We even have a wheel strap designed for E tracks, part #EM58523 which will work great.

view full answer...