Review of etrailer E Track - E-Track Rails 4 Pack - e62VR Video

On an 4 foot long section of E-track #EM19147 and 2 screws every 16 inches that is a total of 6 screws in the aluminum frame. This most likely will not get you near the capacity of the E-track. I recommend bolting through the aluminum frame so that…

Yes we do have backing plates for the e-tracks. I recommend going with etrailer E-Track Backing Plates w/ Hardware - Galvanized Steel - 6" Long x 6" Wide - Qty 4 #e66RR which is a nice kit that includes 4 plates and all the necessary…

The Erickson E-Track Tie-Down Anchor #EM37JR is 5.2" Long, 5.2" wide and 0.5" tall. The two 5/16" holes are centered on each side of the of the bracket 2.75" from each other. Please see the attached image.

For your Dodge Challenger I recommend using the Erickson E-Track Tie-Down Kit #EM58523-09162-4. With this kit you get 4 e-track wheel straps that will provide you a great way of securing your Challenger. The straps will be easier to route around the…

The Bulldog Winch Ratcheting Wheel Tie-Down Strap #BDW20362 is designed to connect to a D-Ring type of connection point so you wouldn't need to install an e-track on your trailer. For your application I recommend installing the Brophy D-Ring Tie…

You will use metal screws to install the etrailer Horizontal E-Track #e42VR. You'll also need backing plates to install this e-track and the mounting hardware is actually included with the etrailer E-Track Backing Plates with Hardware #e76YR. The…

You can pretty easily go from a 205/75-14 to a 15 inch tire size like 205/75-15 like with the #AM32395 without clearance issues. This will give you a slightly larger wheel and tire which will have a higher weight capacity. So you might gain a slight…

The etrailer e-track system #e42VR will work great in your aluminum utility trailer, but you will want to put a layer between the E-Track and the aluminum of your trailer. This layer will help prevent corrosion cause by contact of dissimilar metals.…

I do have a solution for you, but I think welding something to the floor is going to really limit where you can place things to have them tied down. I don't think you're going to be able to get away from the issue with galvanic corrosion…

I reached out to my contact at Tow-Rax who confirmed that you can use the Tow-Rax Low-Profile Floor Track #TWSP72TA to install a winch mounting bracket on. The tracks will hold up just fine but you will want to make sure that your mounting hardware…

Powder coating and galvanization are both about the same in terms of rust resistance. If you like the black of the part #e42VR it would work just as well as a galvanized version #e62VR.

Tow Rax states that the capacity for the Tow-Rax Low-Profile Floor Track #TWSP72TA is based on the attachments that are used in it. So in your case you'd just be limited by the capacity of the anchors you installed in the track. The amount of…