What is the Diameter of the Valve Stem Hole for Taskmaster Trailer Wheel

Question

Question:

What is the diameter of the valve stem hole?

asked by: Kaden

0

Expert Reply:

The valve stem hole in Taskmaster trailer wheel # TTW550550WS1 is 0.453 inches in diameter. We have a couple of valve stems that fit that size. Valve stem # AM20903 is rated for up to 65 psi which is what the valve stem on the wheel is supposed to be rated for. Or we have # AM20904 rated up to 80 psi.

expert reply by: Michael H

0

Answer 1

For any 16" wheel it takes a 5/8 .625 valve stem. I recommend Americana Metal, Bolt-In Valve Stem - 1-1/4" Long Item #AM20906

view full answer...

Answer 2

The valve stem opening for the Aluminum Liger Trailer Wheel - 16" x 6" Rim - 6 on 5-1/2 - Silver #LH97FR is 0.453" which is standard for wheels with a 16" diameter and smaller. To replace your valve stems you'll want to go…

view full answer...

Answer 3

Measure the diameter of the hole the the valve stem is coming through in the picture you submitted. With that you'll be able to find which valve stem you need. The two common sizes are .453 and .625 inch which the part #AM20906 is a confirmed fit…

view full answer...

Answer 4

Since most valve stems are rubber they will start to dry rot and should typically be replaced at the same time you replace your tires. When looking for new valve stems you'll want to ensure that they're rated for the PSI of your tires and the…

view full answer...

Answer 5

The HWT #AM22319HWT split spoke trailer wheel would use a valve stem for a .453 inch opening like part #AM20903 for a rubber valve stem or #AM20906 for a chrome plated brass valve stem.

view full answer...

Answer 6

The valve stem you'd want for a 16 inch trailer wheel is the part #AM20906. Most 16 inch trailer wheels have a .625 inch hole for the valve stem to fit which this valve stem works with but also this valve stem can be used with .453 inch valve…

view full answer...

Answer 7

On a 16 inch trailer wheel the correct size valve stem hole would be .625 inch so the replacement valve stem you'd want is the part #335TPMS-6V. This can be used on steel or aluminum wheels too.

view full answer...

Answer 8

The Steel Solid Center Trailer Wheel #AM20053 that you reference have the smaller valve stem hole diameter of .453 inch. We have the high PSI rated chrome-plated brass valve stem part #AM20906 which would work great in this wheel. It actually comes…

view full answer...

Answer 9

See the linked item below for my recommendation: **2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR. The three wires are two red and one black. Black is ground and the red are for power. Only one red is needed however as…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...