What Size Slot is Erickson E-Track Tie Down Ring 59147 Designed to Fit

Question

Question:

Will these snap into the Ford boxlink system?

asked by: Charles

0

Expert Reply:

The # 59147 is designed to fit E-tracks which have a length of 2.45-inches and a width of .58 inches. See attached diagram.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I went and pulled both the part #59131 and #59147 from our warehouse to get the dimensions you requested. The width of both measures 7/16 inch. The overall length of the part #59131 where it clips down into the e-track is 2-13/16 inches. That portion…

view full answer...

Answer 2

For an LED license plate lamp like part #LPL41CB, the black wire is connected to the running light circuit so that the plate is illuminated when the vehicle head lights are turned on, and the white wire is connected to ground.

view full answer...

Answer 3

Yes the E-track accessories like the Tie Down Ring #59131 do fit in the BoxLink cleats in the bed of Ford trucks like your 2018 F-350.

view full answer...

Answer 4

The Optronics Fleet LED Trailer Tail Lights #TLL12RK are a slightly longer light so they aren't a replacement, but we do have the LED replacement you need for the Optronics #ST70RB. That part is the Optronics LED Trailer Tail Light #STL72RB. This…

view full answer...

Answer 5

The Glo-Brite 9553 you have currently measures 6-1/2" x 2-1/4" x 2-1/4" so for an incandescent replacement option I recommend the Custer Trailer Tail Light - Submersible - Stop, Turn, Tail - Incandescent - Oval - Red Lens #G65R which…

view full answer...

Answer 6

When replacing your 6-1/2 inch oval tail light like the Optronics Sealed #ST70RB that does not have any visible screws on your boat trailer, you can remove the assembly by simply pulling it out of the existing grommet. You can wiggle it back and…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

What Size Slot is Erickson E-Track Tie Down Ring 59147 Designed to Fit

Product Page this Question was Asked From

Continue Researching