Trailer Wiring Install Location on 2017 Ford Explorer

Question

Question:

Im looking for the connector for my 2017 Ford explorer

asked by: Kimberly L

0

Expert Reply:

To install trailer wiring on your 2017 Ford Explorer like the part # 118540 you will need to locate the plug for it under the passenger side of the rear bumper. If you check out the picture I attached you can see where it is and also I attached an install video that shows where to find it as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

If you do not have the trailer towing package on your 2017 Ford Explorer then you will want to install the Tekonsha T-One #118540 which will give you a 4-Way for your trailer lights. The Reese #74682 that you referenced is for Explorers with the…

view full answer...

Answer 2

If your 2017 Ford Explorer has the factory prep towing package installed, then you might have a brake controller plug-in wiring on the vehicle to connect your brake controller. However, not all models with the tow package had the wiring installed and…

view full answer...

Answer 3

Both the Curt T-Connector Vehicle Wiring Harness #C56172 and the Tekonsha T-One Harness #118540 referenced in your question are confirmed to fit the 2011-2018 Ford Explorer. Both harnesses will install the exact same way, by plugging into a built-in…

view full answer...

Answer 4

A factory 7-way trailer connector isn't all you need to power a trailer's electric brakes. You still need a brake controller. Some Ford F-150s are equipped with a factory integrated brake controller, which you may have. If your 2012 Ford…

view full answer...

Answer 5

To determine why you do not have any power on the blue brake output wire, I recommend starting at your brake controller. First, make sure the brake controller is on and receiving power. Most brake controllers have 4 wires, blue (brake output to…

view full answer...

Answer 6

I would say that it's entirely possible that since this is a police interceptor model that there just isn't a plug in for a trailer wiring harness on the vehicle anywhere; however I do believe this is unlikely. I would look on the…

view full answer...

Answer 7

If you really wanted to hardwire in a 4-way you could use the part #18252 for trailer wiring in your 2003 Ford Ranger but we have a custom fit, plug-and-play option that will work much better and install a lot easier with the part #118344.

view full answer...

Answer 8

Look at the connector that attaches directly to the light assembly. I attached a picture that shows what the connector will look like that you would need to use.

view full answer...

Answer 9

Are you certain that you have the 6-way connector, like part #PK12720 with the 6 round pins? Or do you have the 7-way connector like part #PK11893 that features 6 blade-type pins with one connector in the center? The two can sometimes be confused.…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...