Brake Controller Harness Location for 2017 Toyota Tacoma

Question

Question:

Where is it located. The manual shows the left kick plate but I couldnt find it.

asked by: Larry

0

Expert Reply:

The brake controller install harness on your 2017 Toyota Tacoma can be hard to find but the part # 3031-P will fit it. If you check out the picture I attached you will see where a customer found the connectors in a Tacoma just like yours.

expert reply by: Jameson C

0

click to enlarge

Answer 1

On a 2017 Toyota Tacoma the location to install the #3031-P is behind the kick panel to the left of your left foot. I attached a picture. You'll need to pull off the kick panel.

view full answer...

Answer 2

If you have a 2017 Toyota Tacoma with the tow package/factory 7-way yes it is pre-wired for a brake controller. For a brake controller I recommend the Prodigy P3 Brake Controller part #90195. This is our best selling brake controller because of how…

view full answer...

Answer 3

The first thing to check is to make sure that the sensitivity or output settings on your Curt Echo #C51180 did not change from your original settings. It also may be beneficial to re-adjust the controller from scratch. In order to do this, Curt…

view full answer...

Answer 4

When GM began manufacturing the New Body Style in 2007, they eliminated the need for a wiring adapter harness (until the 2014 model year, when they went back to using a harness). The tow package wiring harness is bundled up under the dash, and…

view full answer...

Answer 5

Yes, when installing the brake controller install harness part #3031-P you do have to run the extra ground wire.

view full answer...

Answer 6

The current version of the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger #PD4060K does have a switch that allows you to switch to lithium batteries. But this switch didn't get incorporated until 2020. From the picture…

view full answer...

Answer 7

I attached a picture that shows the switch of the Progressive Dynamics converter part #PD4060K which allows you to switch between lead acid and lithium batteries. In case the picture doesn't make it through look on the circuit board near the…

view full answer...

Answer 8

Sounds like you have a blown fuse under the hood of your 2003 Chevy Silverado. The truck will have trailer wiring fuses/relays that are separate from the truck's turn signal fuses. That is why your truck's turn signals are working but the…

view full answer...

Answer 9

Sway control is designed to be used in situations where the trailer sways under adverse conditions such as high winds or when large vehicles are passing causing the trailer to become unstable. Sway control also helps if you have to maneuver suddenly.…

view full answer...

Answer 10

Bar style friction sway control units such as #83660 are not trailer or vehicle specific. On the trailer, the side of the frame will need to be clear 21 through 27 inches back from the center of the ball cavity of the trailer coupler. The bracket…

view full answer...

Answer 11

The brake controller connector is clipped to the back side of a panel located just to the right of the ignition key. You'll need to lower the panel and unclip the connector from the rear of the panel, then feed it down behind the panel so it…

view full answer...

Answer 12

Although you do not have any issues with weight distribution, the best type of sway control we can offer you is in the form of a weight distribution system. For this, I recommend the Fastway e2 Weight Distribution part #FA92-00-0600 which has two…

view full answer...

Brake Controller Harness Location for 2017 Toyota Tacoma

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching