Replacement Landing Gear Motor Recommendation for Venture Landing Gear

Question

Question:

Does this motor still have the cheap plastic tips to hold the motor in place? Is there a suitable replacement with metal tip for the venture model ?

asked by: Pat S

0

Expert Reply:

The tips of the # LC142178 that the install bolts run through are plastic. We do not have a motor that would work that has a metal version of these tips, but if you tighten the bolts down sufficiently they wouldn't break under normal circumstances.

expert reply by: Jameson C

0

Answer 1

The Lippert Components Venture 5th Wheel RV Landing Gear Motor part #LC142178 is the motor you are looking for. This will be a direct replacement for the motor in your 2006 Northwood Artic Fox with Venture landing gear. Be very careful when ordering…

view full answer...

Answer 2

The Replacement Motor #LG-142178 referenced in your question will work perfectly as a replacement on your Venture M-9000-PK landing gear system. This motor features the 4-1/8 inch mounting hole pattern that you are needing and it has a 5,500 pound…

view full answer...

Answer 3

The skipping sound you are hearing is the motor drawing too much amperage and then "clicking" loudly as it fails to have enough amperage to move the landing gear. This is very common if the motor needs replacing or the power or ground for…

view full answer...

Answer 4

Those are a couple of good questions, and to start, I just want to confirm the correct replacement for your Atwood 75721 motor is the Replacement Motor #LG-142178. Now, in regards to removing the motor, it is extremely simple as literally all you…

view full answer...

Answer 5

To determine the best landing gear option for your 1997 Forest River Sierra you'll need to measure the where your weld-stops sit to see if there is a matching set so that you can swap over without having to cut off the old mounting brackets and…

view full answer...

Answer 6

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

view full answer...

Answer 7

The sure way to pick out replacement landing gear for a trailer that will bolt right up to the current brackets is to measure the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) if it…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

From the carpeted "floor" to the top of the railing on the 90" x 26" MORryde RV Cargo Sliding Tray #MR87FR measures 3-1/2" (see attached). If you jump to the 3 minute mark of the linked review video you can see where we take…

view full answer...

Answer 10

From what I could find it looks like your ADTH 1RV-200 motor has a weight capacity of 6,500 lbs. You can use a motor that is rated for a higher capacity, like our replacement motor #LC142178 for Ram landing gear which is rated at 8,000 lbs. Just keep…

view full answer...

Answer 11

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…

view full answer...

Replacement Landing Gear Motor Recommendation for Venture Landing Gear

Product Page this Question was Asked From

Continue Researching