Replacement Motor for Venture M-9000-PK Landing Gear

Question

Question:

I have a 2005 keystone lerado. It has a venture mfg M-9000-pk motor with a 1/2foot output shaft and a 4 1/8f bolt inch pattern. Will this work?

asked by: Steven

0

Expert Reply:

The Replacement Motor # LG-142178 referenced in your question will work perfectly as a replacement on your Venture M-9000-PK landing gear system. This motor features the 4-1/8 inch mounting hole pattern that you are needing and it has a 5,500 pound weight capacity.

I have attached a short video demonstration on this product that you can also check out.

expert reply by: Chris R

0

Answer 1

The replacement motor for your landing gear is #LG-142178 This will work well for you.

view full answer...

Answer 2

To replace your existing Venture motor, the Lippert Components Venture 5th Wheel RV Landing Gear Motor #LC142178 is the correct replacement part for you. For an aluminum gear box, you are correct that you can use part #LG-179015. The #LC142178…

view full answer...

Answer 3

The replacement crank handle #LG-119226 will allow you to manually crank the LCI model 113407 electric stabilizer. I have linked the instructions for the manual override for you to better see where it attaches.

view full answer...

Answer 4

The Atwood manual crank you referenced we no longer carry. The Replacement Crank Handle for Stromberg Carlson Landing Gear #LG-119226 is the manual crank we have that will work for your Atwood Electric Jack. This is a much longer option which would…

view full answer...

Answer 5

Since the gears work easily when not under load and you are able to manually assist the motor when under load, the gears are not the issue. It sounds like the clicking is a relay that is tripping and resetting so it sounds like either the wiring or…

view full answer...

Answer 6

The price difference does seem backwards, but the faster speed part #LG-141893 has the same weight capacity as the lower speed part #LG-142178 that you also referenced. It's a difference of 5,500 RPM and 7,140 RPM so you would definitely see…

view full answer...

Answer 7

The replacement motor for your landing gear is #LG-142178.

view full answer...

Answer 8

The skipping sound you are hearing is the motor drawing too much amperage and then "clicking" loudly as it fails to have enough amperage to move the landing gear. This is very common if the motor needs replacing or the power or…

view full answer...

Answer 9

The Lippert Components Venture 5th Wheel RV Landing Gear Motor part #LC142178 is the motor you are looking for. This will be a direct replacement for the motor in your 2006 Northwood Artic Fox with Venture landing gear. Be very careful when…

view full answer...

Answer 10

Those are a couple of good questions, and to start, I just want to confirm the correct replacement for your Atwood 75721 motor is the Replacement Motor #LG-142178. Now, in regards to removing the motor, it is extremely simple as literally all you…

view full answer...

Answer 11

The tips of the #LC142178 that the install bolts run through are plastic. We do not have a motor that would work that has a metal version of these tips, but if you tighten the bolts down sufficiently they wouldn't break under normal…

view full answer...

Answer 12

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Replacement Motor for Venture M-9000-PK Landing Gear

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching