Videos
for Hitch Fabrication Parts
Help Articles
for Hitch Fabrication Parts
Expert Answers
for Hitch Fabrication Parts
I do have an option for you but the Curt Trailer Hitch Receiver part #C15800 is designed for passenger vehicles like the Ram 3500, Chevrolet Silverado 3500, and GMC Sierra 3500 so it will not fit your 2009 Volvo D13. However, what you can use is…
view full answer...The Buyers Products #3371809042 measures 9-1/2" on the vertical side with the remaining height being 6" down to the bottom. The #3371809043 measures 14-1/2" on the vertical side with…
view full answer...I went to our warehouse and measured the Buyers Products 50 Ton Air Compensated Pintle Hook #337PH50 to get the height dimensions. The overall height of the pintle when open is 12" and when closed is 9-1/2". I also…
view full answer...The best Timbren kit for your 2024 Toyota Tundra is the Timbren Suspension Enhancement System #T45MR rated for 6K. The Off-Road kit and the 7K kit will have the Timbren bumpers engaging a bit quicker than what you'll need with…
view full answer...Yes, the Buyers Products Flatbed/Flatbed Dump Hitch Plate Bumper with Pintle Mount #3371809050 that you referenced does fit the flatbed/dump bed you have on your 2000 C6500. According to Buyers Products this fits your chassis but will require some…
view full answer...The wiring color codes and wire gauge recommendations for the Pollak Heavy-Duty, 7-Pole, Round Pin, Trailer Wiring Connector, item #PK11700, are listed below. White - Ground Return - 8 gauge Black - Clearance, Side Marker, Identification - 12 gauge…
view full answer...I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...We don't have a 7-way splitter like the photo you sent. We instead for applications just like yours recommend using the Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Pole Connector - 7' Long #A10-7007 or the 10 foot…
view full answer...I think the best option we have for you is a universal weld-on hitch plate like one of the following that I have attached for you. We do not really have any direct fit hitch plates for you so I think this will be the best option we can offer. If…
view full answer...The holes on the Buyer's Products Bolt-On 2-1/2" Hitch Receiver #BP82FR are spread 3-1/2" vertically and 3-3/8" horizontally. And the Buyers Products 15 Ton Combination Pintle Hitch w/…
view full answer...I recommend using a Winch #SW39GR with the Hitch Mount #BDW20011. This way you only need a 2" receiver which is typically already on the rear of most trucks and are available for the front. For your tilt trailer you can weld on a…
view full answer...As the Buyers Products Plain Receiver Tube 2-1/2" I.D. x 12" Long #337RT255812 is a fabrication part, the tongue weight capacity will depend on the other parts used and what it will be installed on. Due to this, it does not…
view full answer...