Hey Joshua, If you're needing everything for the vehicle side of the Demco Air Force One kit then you'll want to pick up part #SM99209. For the lighting you'll need the Roadmaster Smart Diode 7-Wire to 6-Wire Wiring Kit for…

I recommend using the Curt Trailer Hitch Receiver #C15809 for your 2006 Dodge Ram 3500. This is a Class V trailer hitch with a 2-1/2" receiver. It has a Gross Towing Weight (GTW) rating of 20,000 lbs and a Tongue Weight (TW) rating of 2,700…

Hey John, yes the Tekonsha brake controller install harness part #3050-P is correct for your 2023 Nissan Frontier and would be what you would need to install the Prodigy P2 part #90885. This harness has one end that was designed to fit your truck…

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

So what you're looking for is a straight tongue coupler for a 2" ball with a 3" channel that can handle at least 7,500 lbs. For a replacement that fits these requirements we have a few options from Demco. If you want a zinc finish with…

With plywood walls that are as thin as yours, it's possible that they may not support what you are looking to do. The only way you will be able to utilize the Erickson Horizontal E-Track #EM59150 (2 feet) or #E19148 (5 feet) is by installing it…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The Aluminum Car Hauler Ramps #288-07501 are 3-3/4" tall. The tabs that fit onto the edge of the trailer are 1" long. I've linked a photo of these dimensions for you to have a look at, as well. These ramps are designed to work at a…

You have a very unique situation. We don't have anything specific to help you with your angle directly, however, you have already done a lot of the work figuring angles and rise needed. I recommend using the Race Ramps Rack Ramps - 5" Lift -…

Yes, we do have those kits. The kit 6212 that you referenced is part #SM99666 on our site. The kit 6237 that you referenced is a combination of parts #SM99226 and #SM99625 on our site.

The Solera Awning Rail Extrusion - Black - 8' #LC715217 has mounting holes that are about 1/4" in diameter. The Self-Tapping Screw - 1/4" -14 x 3/4" #FA1131822 is the recommended screw for this and you will also need LaSalle…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…