Race Ramps Trailer Loading Assist Ramps Review Video

If you are only putting brakes like the #TRU36FR on one axle, we recommend doing the front axle for a few reasons. First, the front axle technically will bear more weight than the rear. Most trailers it would be about 60% on the front axle and 40% of…

The battery on the trailer will not charge if it is attached to the 12V power wire from the towing vehicle. It will provide a small amount of current that helps maintain the current charge of the trailer battery. I recommend using a battery charger…

In order to charge the 12-volt auxiliary battery on your enclosed travel, I recommend taking a look at the Redarc In-Vehicle BCDC Battery Charger #331-BCDC1225D. This will use the power created from the vehicle's alternator to provide a charge to…

Typically converting a mobile home axle is a challenge, but the drawing you provided shows that your spindle uses an #LM67048 outer bearing and #25580 inner bearing. These are both fairly common bearing sizes, so there is an available solution. To…

If your breakaway battery is dead, your brakes should operate while connected to your vehicle's 7-way trailer connector. If your brakes are not operating, then it sounds like you might have a short in the brake wiring of the trailer. Battery…

For a Bobcat 331 that weighs up to 7,500 lbs I'd recommend the 10k ramps part #325-GH-R96 that you referenced which are 96 inches long and 15 inches wide. I attached a picture of a heavier tractor being loaded with these ramps as well as a review…

The SuperWinch LT2000 Electric Utility Winch, part #1120210, you have referenced will only have a rated line pull of 2,000 lbs. The rated line pull of 2,000 lbs. will pull a rolling load of 10,050 lbs. up a 6 degree incline, but as the incline…

For vehicles that are low to the ground the longer the ramp is the better because the amount of lift is more gradual over a longer distance. If you like the Race Ramps we have #RR-TR-8XL which are 6 feet long so for every foot of ramp the height…

The Standard Trailer Light Kit with 25' Wire Harness part #TL29BK as I am sure you noticed grounds via the mounting hardware therefore there is not a singular ground wire. In order to attach this light to a wooden surface you will need to run a…

It would be ideal if the middle ramp is longer than the two outside ramps while loading. This would ensure there are minimal ground clearance issues but there are a multitude of factors that would come into play so it's hard to predict this…

If it were my trailer I would fasten the E-Track to the support beams under the trailer, either the side to side one or front to back ones, by going all the way through those support beams. E-Track like #E19148 is zinc-coated steel and since the…

For your Aluma 6810 HBT trailer, I recommend the Erickson Horizontal E-Track - Zinc Coated Steel - 2,000 lbs - 5' Long - Qty 1 #E19148 along with the E-Track Backing Plate - Zinc Plated Steel - 6" Long x 6" Wide #e96RR. This will save…