Filter Products
Filter Results
$89.12 - $98.72
$103.67 - $175.36
Filter by Coupler Size Compatibility
$89.12 - $98.72
$103.67 - $175.36
Videos
for A-Frame Trailer Coupler
Help Articles
for A-Frame Trailer Coupler
Expert Answers
for A-Frame Trailer Coupler
I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...We currently have three versions of the Demco 32 degree A-Frame coupler but none of them are zinc plated. We have the part #DM15633-97 which is primered, the part #DM15633-81 which is powder coated black, and we have the part #DM15633-52 which is…
view full answer...The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions…
view full answer...I checked the Featherlite Trailer website for specs on the model 3116 trailer but this part number returned no results. But if your trailer uses an industry-standard 50-degree a-frame design then the Demco A-Frame Trailer Coupler #DM16680-52 will…
view full answer...To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts…
view full answer...The play you are feeling/hearing is most likely between the hitch ball and the latch of the coupler. If you look under the coupler you can see an adjustment bolt that uses an Allen wrench that will allow you to tighten the latch and get rid of the…
view full answer...An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…
view full answer...The Curt QuickPin No Latch A-Frame Trailer Coupler 25474 #C84DR will require grade 5 hardware. It is recommended to use six 1/2" bolts, six 1/2" lock nuts and twelve 1/2" washers. This can obviously change…
view full answer...If you look at the diagram that I received from my contact at Demco, you can see several of the dimensions of the #DM14793-81 trailer coupler. If there were other dimensions you were needing, please let me know.
view full answer...The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.
view full answer...There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!
view full answer...I have a solution for you. We do not carry hardware kits for the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR. However the instructions will give you the dimensions you will need and you…
view full answer...