Review of Demco A-Frame Trailer Coupler - eZ Latch Standard Coupler - 12660-97SP Video

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Both styles of Demco couplers are going to hold up well but in general cast steel is considered to be better due to it's uniform and more consistent structure it provides. Stamped steel is typically considered a more cost effective solution…

I attached a picture that has the dimension of the #BDSPBQ50 that you referenced. I wasn't sure what other plate you were referring to so I grabbed dimensions for the #BD003135 and the #DL22763.

We currently have 3 different trailer jack support plates. I have included other dimensions in the included photos except for #BDSPB50 which was not available. #DL22763 is 1/8 inch thick. #BD003135 is 1/8 inch thick. #BDSPB50 is 1/8 inch thick. The…

It would appear that that your 1978 Airstream had the standard 50 degree a-frame style coupler. You can verify this to ensure that the etrailer A-Frame Trailer Coupler #CA-5280-RB will fit correctly on your Airstream. I personally prefer the auto…

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for attaching the…

The Ez-latch a-frame coupler we have that will accommodate your trailer's tongue is a little longer than your measurements. It is the Demco 32-Degree A-Frame Trailer Coupler w/ Jack Hole item #DM15633-81. This has the requested Ez-latch and fits…

The standard a-frame coupler degree is 50 degrees but we do have a 32 degree coupler with the part #DM15633-81 but the rear width of it is 9-7/16 inches.

Silver is just the color that Demco likes for their couplers which is why the Demco 50-Degree A-Frame Coupler #DM15349-52 is that color. The two most popular colors are black and silver like this. Demco does offer a red primer version of some…

For the clearance light part #AL91RB we have the grommet part #A91GB which is basically a hard rubber.

You could technically wire an electric trailer jack directly to your truck's battery, but that isn't really the most practical setup. I've seen one guy pull out his jumper cables every time he wanted to use the jack in this fashion, but I…

If the front part of your square-bodied coupler is approximately 3 inches tall, based on the inner dimensions of the lock the Blaylock EZ Lock Trailer Coupler Lock #BLTL-33 will work well for you. The #BLTL-33 has inner dimensions of 3-1/8 inches x…