SeeLeveL RV Holding Tank Monitoring System - Fresh, Gray, Black - Multiplex Compatible

Video Transcript for Review of SeeLeveL Smart RV - Monitoring System - SE99VR

Hello, everybody. This is Jeff at etrailer.com. Today we're gonna take a look at the SeaLeveL RV Holding Tank Monitoring System for your fresh, gray and black tanks, and it is multiplex compatible. Now, basically, if your RV tank monitor readings will change from 25% to empty and just the blink of an eye, that could be a problem. What's nice with this monitoring system, this will track and display the levels of the RV's holding tanks at just the push of a button. This will hardwire to your SeaLeveL sensors.

It includes three 12 inch long sensors for fresh, gray and black tanks. And what happens is with traditional tank monitors, they have a reputation for being unreliable. Basically, they only use a few sensors which are installed inside the tank, meaning that they'll usually only measure in quarter increments, and they can send false readings if they get dirty. So when you're keeping an eye on how much fresh water you have, the difference between 25% full and empty can mean a lot, and that inaccuracy can be a problem. What's nice with these sensors, these can mount to the outside of the holding tanks, rather than using interior probes.

So we mentioned, it includes three sensors. They're 12 inches long. These will prevent false readings caused by accumulating debris. They'll provide readings with single digit accuracy. And what's nice is these can be trimmed or stacked with an additional sensor to match your tank size.

Basically, one 12 inch sensor here can accommodate a five inch, up to a 13 inch tall tank. And if you stack an additional sensor on it, you can accommodate tanks up to 25 inches tall. The displayed monitor that comes with this will show your fresh, gray and black levels in percent. And then if you push the battery, it'll show your battery voltage. Does have a diagnostic mode, which will check status and signal strength of the sensors.

And it has air codes which will alert you of any issues. And you'll check the manual for the suggested solutions to those issues. Now we mentioned this is multiplex compatible. Basically, it's compatible with the RV-C Multiplex Systems to display tank levels on your center console. You can use multiple monitors, so that you can check the tank status from your service bay or inside your RV. Now, this is a very easy installation. All you have to do is, if you look at the back of your display monitor, if you cut out a three inch by one and seven eight inch hole, and it'll let you recess this monitor. And then, what you do on your sensors, you just remove the backing and attach the sensors onto the tanks and then hardwired them together. If you notice, it includes pigtails on each sensor, which is needed for installation. The tabs up at the very top of the sensor, they're trimmed to indicate which tank gets on. And we mentioned, these sensors can be trimmed. And there are sections, you can see, every one and a half inches to match the height of the tank you're putting it on. The bus wiring will let all the sensors splice together to one line. And also what's nice is the existing wiring from your old tank monitor system can be used to install these. A few specs, again. The application. This is for a three tank system on your RV or motor home. The sensor length, we told you, is 12 inches. Now, the monitor, the outside dimension of it is gonna be right at four inches by two and three quarter inches tall. And the depth of it is only three quarters of an inch deep. But that should do it for the review on the SeaLeveL RV Holding Tank Monitoring System for your fresh, gray and black tanks and multiplex compatible.