TireMinder 90 Degree Valve Extender - Qty 2

Video Transcript for Review of TireMinder Tire Repair Tools - 90 Degree Valve Extenders -TM97SR

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at the TireMinder 90 Degree Valve Extenders for a quantity of two. Now these valve extenders, you can notice, have a 90 degree bend on them, and that'll allow you to better access those backward-facing metal valve stems on your wheels. Now this will fit most metal valve stems front or rear, but they're mostly designed for those valve stems on the rear wheels of your RV that are harder to reach. Now these are for metal valve stems, they're not recommended for use on rubber valve stems. They are a nickel plated brass construction.

They are TPMS compatible. Total length on them is about two inches. And the way you install them, this end right here, will screw onto your current valve stem and then the other end right here has the metal valve cap that you'll remove to access your air pressure. And just to demonstrate, I happened to pull a metal valve stem. There's your metal valve stem, has a cap on it.

What you'll do is remove your valve cap that's on the valve stem that's on the wheel. And then you'll take your extender, take that in and start screwing it on there, and just screw it and tighten it all the way down. And then you just wanna make sure it snugs up because there is a seal in there that you'll want to seal. And there it's nice and tight. Now you see it's changed your access to a 90 degree.

And then you just take your valve cap off here, and that'll let you hook up your pressure gauge or air hose to that to check the air, put air in there. And then to remove them, just unscrew it from your valve stem. And as we mentioned, they are TPMS compatible. But that should do it for the review on the TireMinder 90 Degree Valve Extenders for a quantity of two.