TireMinder Straight Valve Extender - 3" - Qty 2

Video Transcript for Review of TireMinder Tire Repair Tools - Straight Valve Extender - TM79SR

Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at the TireMinder three-inch long straight valve extenders. It's for a quantity of two of those. Now, these valve extenders will allow you to add an additional straight three inches of length to your metal valve stems to let you easily inflate or check the air pressure on those hard to reach valve stems. Now, these are recommended for metal valve stems.

They're not to be used on rubber valve stems. These are a nice nickel plated brass construction. They are TPMS compatible. Basically, what happens is right down here, you can see one end will screw onto your current valve stem, extends out three inches, and then the other end just has your normal metal valve cap on. Then when you take it off, there's your Schrader valve that you can put your air in or put your pressure gauge on there to check the air.

But just to show you, I wanted to demonstrate. Here's an example of a metal valve stem. So, what you'll do is take your valve cap off the valve stem that's on there, take this in, put it right on there. Go ahead and tighten this down all the way. And you wanna screw it down all the way 'cause what that does is there's a shaft on the inside that will push down on that.

So up here, then when you take your valve cap off and you push on that Schrader valve, it'll push down there and open that one up. So, it's basically extending your valve out three inches to make it easier to access. And then again, just to show you that actual measurement, if we take one of these, the very tip, there's your three inches. But that should do it for the review on the TireMinder three-inch long straight valve extenders for a quantity of two.