These extra-secure, 1-way female snaps ensure your boat cover stays attached. Install the female ends with the die and setting tool (3691360 - sold separately). Snaps only undo when you pull the dotted edges.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hey everyone. I'm Ellen here etrailer.com and we'll be taking a quick look at the tailor-made one way, snap fasteners. These are going to be the female side for attaching to your fabric boat cover.So this allows you to either repair a damaged or missing snap fastener on that boat cover to make it nice and secure, or maybe you just want to add some extra ones to make sure that cover is really snug around your boat or on your cockpit cover.So this allows you to do that. It comes with four snaps to get those installed. So let's take a closer look and talk a little bit about how those are going to get put in place. So you can see we'll have our stem end and then the other side.
So this is going to go over, or the fabric is going to go in between these two and then you will need to use a tailor-made snap fastener installation tool to actually push that down and install it. That is sold separately. You can find it here at etrailer.com. A good idea to pick that up while you're here to make sure that you can even install those in place.These are also going to snap into the male side, which typically is going to go into a wooden material and you can also find those male ends sold separately here, and they are also a related product on the product page here at etrailer.So it's a one-way design. Really the only way to remove them is to pull on the dot, which is going to be this side.
So it should be pretty long lasting and give you that secure snap around your fabric cover. They are made in the USA, and that's going to do it for our look at the tailor-made one way snap fasteners for your boat cover. I hope this has been helpful in deciding if this is the right part for you. We do have a lot of boating accessories available here at etrailer.com. So check them out.
Thanks for watching.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
These extra-secure, 1-way female snaps ensure your boat cover stays attached. Install the female ends with the die and setting tool (3691360 - sold separately). Snaps only undo when you pull the dotted edges.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.