Most Popular Yates Rubber
Videos
for Yates Rubber
Help Articles
for Yates Rubber
Expert Answers
for Yates Rubber
I went out in the warehouse and pulled the Redline Grease Seal, part #13194. It does have the markings on the inside of the seal that say TCM 13194 TM Taiwan and the number 11. It also has the spring around the inside lip. This seal will work for…
view full answer...The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…
view full answer...I attached a picture that we recieved from a customer that shows the CE Smith winch mount #CE31013G installed and in use on a trailer for you to check out.
view full answer...You are correct, CE Smith Trailer Idler Hub Assembly w/ Case for 2.7K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased #CE13315 is exactly what you are looking for. This fits your 13" wheels with 5 on 4-1/2 bolt pattern. It comes pre-greased and…
view full answer...It would be best to stay with the sizes you currently have (assuming everything is working well), as changing the roller diameter can affect how the hull meets up with the bow stop or rollers if your trailer is so equipped. One of my friends had the…
view full answer...If you're getting that much bounce out of your trailer that would lead me to believe that maybe the MORryde IS suspension system is the actual issue. Typically if the suspension is too stiff you'll start to bounce. We see this issue a lot…
view full answer...Since your old V-bar light only uses a single wire it grounds the light through the mounting hardware. You will simply need to add a Ring Terminal #DW05736-1 to the ground wire on the V-Shaped Identification Light Bar #TN23MR. Then you will be able…
view full answer...My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…
view full answer...Since your main concern is the marks on the hull of your boat I recommend going to the Yates TPR Ribbed Wobble Roller. These rollers are constructed of thermal-plasticized rubber which is a non-marking, non-scratching material. It is stronger and…
view full answer...Since the tongue of your trailer flares out you could just cut a piece of wood to match the angle of the flare to square up the tongue and then clamp-on the etrailer Round/Wheeled Swivel Jack #e79CR. If the trailer stays outside a majority of the…
view full answer...We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…
view full answer...You need the Yates Ribbed Wobble Roller #YR500YW-8P. It matches your roller at 5" in diameter, 3" wide and uses a 1-1/2" long bushing to fit on a 1" shaft. The Washer For 1" Spindle #SW1000 are sold individually so be sure to…
view full answer...
What our customers are saying:
"I fond the internet sight very helpful. I was able to get answers to all my questions. The on-line installation instructions and videos were very helpful. I felt as if I had done this installation before. Fast delivery. Rich"